What order do you paint a panel door?

Painting a panel door

1. Panel doors should be painted in the following order:
2. A. Top edge of door. B. Side edges of door. C. Panel moulding. D. Panel area. E.
3. Caution should be taken to prevent any runs or drips during the painting of the door, especially on the bottom edges of the panels.
4. Finally paint the door frame.

What order do you paint a 6 panel door?

For a standard 6-panel door, this is the order to go in:

1. Start by painting the edges of the door with either the brush or roller.
2. Next, paint the door panels.
3. Then paint the three vertical strips down the center with the 4″ roller.
4. Next, paint the four horizontal rails with the 4″ roller.

What are the steps to paint a door?

Instructions for How to Paint a Door

1. Step 1: Select Door Paint. For one primed exterior door, you’ll need at least one quart of paint.
2. Step 2: Remove and Restore the Door. Remove the door and all of the hardware.
3. Step 3: Apply Primer.
4. Step 4: Apply Front Door Paint.
5. Step 5: Dry and Reattach.

Which is the correct order to paint a panel door?

OK, here is the order to paint your panel door: Paint the door edge, you should always paint the edge you will see if the door is open. Number 1 in diagram. If it is an exterior door you should also paint the top of the door, and the bottom if you can.

How long does it take to paint a panel door?

Doing it in this order enables you to get a coat on the whole panel door in one sitting so you only have to have 2-3 painting sessions (rather than 4-6 if you were doing one side at a time and waiting for it to dry in between.)

What kind of paint do you use to paint a door?

Having completed the outside of the door, paint the inside of the door in a similar manner. Then, using a small brush (25mm (1 inch)), carefully paint the edges of the door (12 and 13), making sure that paint does not ‘turn the corner’ onto the completed sides – first paint the hinge edge of the door and then the lock edge.

Can you paint a panel door with a roller?

Learn how to paint a panel door with a roller in just a few hours without leaving any drips or streaks! Remove the door from its hinges leaving the hinges attached to the door jam. Put plastic on the floor and wall where you plan to lean the door. Tape (or remove) the doorknob hardware and tape inside the hinge notches.