Guidelines

How do you reset a Frigidaire stove F10?

How do you reset a Frigidaire stove F10?

If you see an F10 error code, reset the control board by unplugging the range’s power cord and tripping the relevant breaker switch. Wait one minute, restore power, and then run a test by reheating the oven.

What does F10 mean on my Frigidaire stove?

runaway temperature
On most Frigidaire ranges, the F10 indicates that the control detects a runaway temperature in the oven. If this fault code appears when the oven is at room temperature, then the failure points to a failed oven temperature sensor probe circuit or a bad electronic oven control board.

How do you reset the code on a Frigidaire stove?

Resetting the Display To stop the flashing and beeping, press the “Cancel” button to stop the beeping and clear the error code. Try the bake or broil feature once more, and if the error code repeats, unplug the appliance and wait five minutes before plugging it back in.

What does F10 error mean on a stove?

runaway oven temperature
The F10 error code indicates a runaway oven temperature. If oven is overheating, disconnect power. If oven continues to overheat when the power is reapplied, replace EOC (Electronic Oven Control). Severe overheating may require the entire oven to be replaced should damage be extensive.

What causes an F10 code on a Frigidaire oven?

If this happens repeatedly, you can severely damage your oven. A faulty RTD sensor probe is one of the causes for an F10 code or overheating oven. The sensor probe is supposed to detect the exact temperature in the Frigidaire electric range cavity and relay it to the oven’s main control so it knows when to shut off the heating elements.

How do you reset the temperature of a Frigidaire oven?

Press “Self Clean” to reset the oven’s internal temperature to a cooler setting. Pressing “Self Clean” in this instance does not turn on the self-cleaning function. It simply lets the oven know that you are decreasing the temperature.

What does F1 mean on a Frigidaire oven?

F1 or F10 – Runaway temperature. If these error codes shown while the oven is in day time mode, the EOC would need to be replaced. Otherwise check the oven temperature sensor (RTD sensor) as described earlier and replace if necessary.

Where is the Frigidaire Range F10 probe located?

Open the oven door and if you do not see two screws right beside the probe then yours is mounted on the back side of the range. If you don’t see it directly on the back of the range as shown in the picture above, then take the back access panel off and look on the right side and you will see it mounted there.