How do you remove a Netgear router?

Software

1. Click “Start | Control Panel | Programs | Programs and Features.”
2. Click the “Netgear” software from the list of installed programs.
3. Click “Uninstall” from the top toolbar and click “Yes” to the confirmation dialog to uninstall the Netgear software.

How do I reset my DD-WRT to factory settings?

The following procedure will clear out the NVRAM and set dd-wrt back to default values:

1. With the unit powered on, press and hold the reset button on back of unit for 30 seconds.
2. Without releasing the reset button, unplug the unit and hold reset for another 30 seconds.

What kind of firmware does Netgear wndr3400 use?

Blame Broadcom for this, not the OpenWrt developers. The WNDR3400 utilizes Broadcom architecture brcm47xx. Different factory firmware seem to contain different nvram variables that affect board detection code.

How to remove and restore DD-WRT firmware?

Solved: Removing dd-wrt firmware and restoring to factory – NETGEAR Communities 2015-11-05 02:38 PM 2015-11-05 02:38 PM Hi, I have a Nighthawk R8000 which I bought with DD-Wrt firmware installed. I would like to remove that firmware and restore to a factory configuration. I might have messed things up.

How to use OpenWrt on a Netgear router?

Select the OpenWrt image from your computer (ex: openwrt-18.06.2-brcm47xx-mips74k-netgear-wndr3400-v3-squashfs.chk), then select Upload and confirm. You should see the message “Note: It will take about 1.5 minutes for firmware upgrade. Please don’t turn off the power…” Then you will see the message “Rebooting the router now, please wait.”

How do I factory reset my Netgear router?

First, do a factory reset of the device. With the power on, press and hold the reset button for about 8 seconds until the power light begins to blink slowly. Release the reset button and the device will restart. Connect your computer to one of the LAN ports on the router.