How do I reset my port settings?
How do I reset my port settings?
How to reset COM ports?
- Click Start – write regedit then click Enter.
- Navigate through folders: HKEY_LOCAL_MACHINE\SYSTEM\CurrentConstrolSet\Control\COM Name Arbiter.
- Double-click right click ComDB on right panel. This will open a window with addresses ports. To reset, enter all zeros, as shown below:
How do I clear my interface configuration?
In V200R001C00 and later versions, you can run the clear configuration interface GigabitEthernet 1/0/2 command in the system view to clear all interface configurations. However, this command will shut down the interface. To enable the interface, run the undo shutdown command in the interface view.
How do I clear the running config on a Cisco router?
To clear out the running config file, simply erase the startup config file and then reload the device.
How do I close a port on a Cisco switch?
The shutdown command causes a port to stop forwarding. You can enable the port with the no shutdown command. The no shutdown command has no effect if the port is a static-access port assigned to a VLAN that has been deleted, suspended, or shut down.
How to clear port config in Cisco Catalyst?
Use the command below to clear the configuration on a port. Use the command below to verify that the running config for the port has been reset to the default configuration. Building configuration… ! Now write your changes to memory.
How to reset a 2960x to factory-Cisco community?
I am unable to successfully use the method where you hold down the mode button. So, I go to CLI and erase the config.text and vlan.dat files. and then use reload command. It asks me if I want to save: None of the insturctions tell me what to do.
What is the MAC address for Cisco 2960?
Using driver version 1 for media type 1 Base ethernet MAC Address: 4c:30:2d:81:ef:80 Xmodem file system is available. The password-recovery mechanism is enabled. The system has been interrupted prior to initializing the flash filesystem.
How to join the Cisco community clear config interface?
Members & Recognition Cisco Community Technology and Support Networking Switching clear config – interface Announcements 197184 Views 70 Helpful 5 Replies dkblee Beginner Mark as New Bookmark Subscribe Mute Subscribe to RSS Feed Permalink Print Email to a Friend Report Inappropriate Content 06-23-201008:30 PM 06-23-201008:30 PM