Does LC2i need a fuse?

The LC2i requires a +12V in order to run properly. For best results, the +12V should be provided by the battery via direct line or from a power distro-block. The preferred wire gauge for the connection is a 18 AWG, and a 1A fuse is recommended.

Why does my LC2i say maximized?

The Maximized light on the LC2i is a warning for when distorted signal is sent to the outputs of the device. When the light is blinking or solid, this is the indicator that the signal is distorting going out of the unit.

What is the difference between LC7i and LC2i?

The main difference is that the LC2i has two channels and the LC7i has 6.

What is a lc2?

The LC2i, is a compact, two-channel processor with active input circuitry, which allows it to accept speaker-level signals of up to 400 watts per channel from factory-installed source units or amplifiers.

How does the LC2i work?

The LC2i, is a compact, two-channel processor with active input circuitry, which allows it to accept speaker-level signals of up to 400 watts per channel from factory-installed source units or amplifiers. Users can enjoy maximum sound quality while maintaining the use of factory volume and steering wheel controls.

How do you tune a lci2?

How to setup AccuBASS on the LC2i

1. Turn the AccuBASS Threshold all the way to the left.
2. Set the AccuBASS Level knob at the 12 O’clock position.
3. Start playing music that is familiar and/or has a lot of bass.
4. Slowly turn the volume up on the head unit until the bass starts to drop out (roll off)

What does the LC2i do?

How do I setup my AccuBASS?

What does a LC2 audio control do?

What is a subwoofer converter?

This converts the speaker – level signal from your head unit to a balanced input level to drive your subwoofer amp, which then is connected to however many speakers you want. You could use two if you wanted to drive two subwoofer amps, connecting one converter to each (left and right) speaker output.

How can I get better bass from my lc2i?

Set the AccuBASS®Level control on the top of LC2i to the center detent. 5. Now, use a small screwdriver to turn the Threshold control clockwise slowly until you hear the bass pop back in. 6. Re-adjust the AccuBASS®Level control on the top of the unit to get the proper amount of bass compensation, and you’re ready for some ground pounding bass.

How does the lc2i turn on the amplifier?

After the LC2i turns on, it provides a 12 volt trigger output to turn on your amplifier. A Jumper which you can reach from the end panel allows you to set this feature on/off for specialized installations.

Do you need ground and power for lc2i?

However you still need power and ground. Connect the speaker level inputs and as soon as you turn on the factory audio system the LC2i will power up as well. After the LC2i turns on, it provides a 12 volt trigger output to turn on your amplifier.