Articles

What does antenna warning mean on Cobra CB?

What does antenna warning mean on Cobra CB?

The swr is too high. You may have a coax damaged or a bad antenna. Do not operate the radio on transmit until this is resolved or it may damage the radio. Posted on Dec 01, 2014.

What does it mean when the red antenna light on Cobra 29?

Your tx/rx light should turn red when you transmit and be green all other times. Your ant light should not light up unless the swr is higher than 3.0; then there is a problem. A common reason for the ant light to light up is that the antenna is not grounded properly.

How do I know if my CB antenna is bad?

Luckily, testing an antenna is a fairly easy process….Testing for a Defective CB Antenna

  1. Using your multimeter, touch one of the probes to the metallic end of the antenna.
  2. Touch the other probe to the metallic threads at the end of the antenna.
  3. As you maintain contact with both probes, measure the circuit’s resistance.

What is the best antenna for a Cobra 29 LX CB radio?

Cobra LX 29 will work with a lot of CB antennas. But our verdict on its best compatible antennas is Wilson 5000 Magnet CB antenna and Cobra HGA 1500 CB antenna.

Why is my CB radio not working?

Make sure your CB mic is plugged in securely. Check for breaks or damage to the plug and cord. Check the pins in the radio for damage as well. If it is a power mic or echo mic, make sure there is a battery in it!

Why is my CB not transmitting?

Yep it’s sounding like it has a bad power or ground connection. A weak power or ground connection can provide enough power for the CB to turn on & receive but not be able to pass the additional power (current) required by the CB when it is trying to transmit.

What does TX mean on CB?

TX and RX are abbreviations for Transmit and Receive, respectively.

Does a CB antenna have to be grounded?

Ground Your Antenna Mount If you’re using a standard CB antenna (i.e., anything except a no ground plane, or NGP, kit), you’ll need to make sure your antenna mount is solidly grounded to the vehicle’s chassis. To ensure a good ground, check that your mount has a direct metal-on-metal connection to your vehicle’s frame.

What is Delta Tune on Cobra 29 LX?

The Delta Tune controls the frequency your radio’s receiver is operating on. You may notice similarities to a clarifier control on other CB’s, and while both these controls do similar things, they are not used for the same purpose.

Does coax length affect SWR?

Coaxial Cable Length Does Not Change Antenna SWR.

Why does antenna warning light go out on Cobra 29lx?

Can’t have the coax being pressed or mashed, it needs to be roughted correctly to not be crushed ect. The coax can be tested by connecting a Dummy Load at the Antenna end of the Coax, the Antenna Warning Light should go out if the Coax is ok.

Where is the coax on a Cobra 29lx?

The coax is RG-58 9′ long and runs through a little opening of the driver side door and continues behind the dash and then up to the radio. Here are some pics so you have a general idea. Close to Toronto ON. I’d say the wire is broken from being bent and swished in the door over and over. You could confirm this with a Multimeter.

What makes the antenna warning light go out?

The coax can be tested by connecting a Dummy Load at the Antenna end of the Coax, the Antenna Warning Light should go out if the Coax is ok. I hear a lot of guys having problems with the Wilson 2000 truck antennas. A local had the same SWR problems and we switched to a Wilson 5000 to fix it, it was mounted on a tool box just aft of the truck cab.

What should I do about CB antenna warning?

Try to root it in a away to minimize this and your good to go. Try moving it to the passenger side and replacing that antenna wire. Less traffic gets longer use out of it. Pull the molding back and you should find a notch just big enough for your wire to just fit through ( hopefully).