How do you descale an autoclave?

Autoclave Maintenance Guide

1. Here are a few simple steps to a hassle-free cleaning with Chamber Brite.
2. Sprinkle Chamber Brite powder along the bottom of the autoclave chamber.
3. Start a sterilization cycle with distilled water but no drying cycle.
4. At the end of the cycle, drain solution from reservoir and discard.

How do you open a tuttnauer autoclave?

Start the cycle by pressing the START/STOP key. At the end of a successful cycle, the screen shows the “Cycle Ended” message and the door is automatically unlocked. Open the door and use the tray handle or wear heat-resistant gloves to remove the load from the autoclave.

Where to place chamber Brite in cold autoclave?

Place the Chamber Brite tablet at the back of the cold autoclave chamber 2. Select a sterilization cycle with water but no drying cycle and press start 3. At the end of the sterilization cycle, drain the solution from the reservoir and discard 4. Fill the reservoir with water and repeat steps 2 and 3 without the Chamber Brite tablet 5.

How to fill water in a Tuttnauer autoclave?

Make sure the water reservoir is filled with steam distilled water. Set temperature to 273⁰F (134⁰C). With the chamber door OPEN, turn the multivalve clockwise from “0“ to “FILL WATER”. Step 4 (continued) Water will begin to flow in from the back of the chamber. Monitor the flow until it gets to the indentation line at the front of the chamber.

How often should I Clean my Tuttnauer autoclave?

Remember, cleaning and maintenance are an important part to the proper functioning of your Tuttnauer autoclave. It is recommended that your autoclave be cleaned with Chamber Brite™ after every 20 cycles. For a full list of Scheduled & Preventative Maintenance, refer to the Operators Manual.

What’s the best way to clean a chamber Brite?

Few Simple Steps to a Hassle-Free Clean 1. Place the Chamber Brite tablet at the back of the cold autoclave chamber 2. Select a sterilization cycle with water but no drying cycle and press start 5. Wipe the inside of the chamber with a damp cloth or sponge 6. Fill the reservoir with distilled water.