How do I reset my Olympus OMD em5?

How To Reset all settings on Olympus OM-D E-M5 Mark II

1. Press [MENU] button.
2. Select “Reset/Myset” in Shooting Menu 1.
3. Highlight “Reset” and then press >
4. Select “Full” and press OK.
5. Select “Yes” and Press OK.

How do I change the shutter speed on Olympus OMD em5?

1 Answer. In mode M, you choose both the aperture and the shutter speed. […] After rotating the mode dial to M, rotate the main dial to choose the aperture and the sub dial to choose the shutter speed.

How do you set a timer on Olympus OMD?

These directions follow the process of setting-up the custom self-timer on the Olympus OM-D E-M10 Mark III.

1. Press the self-timer button – by default it’s the down navigation control.
2. Scroll right through the self-timer options until one of the two with a C is selected.

How to set flash sync on Olympus OMD Em5 Mark II?

So, to set the flash sync, push the menu button, go to the “gear” on the side, that will get you to the custom settings menus. Look for the lightning bolt, on the m5 is letter “f”. Once you click on it, just scroll through the settings till you find the flash sync. Thanks, but the menus are definitely different….:-

Where are the flash settings on the OM-D E-M5?

Most of these settings assume the flash is in TTL-A mode except where noted. The first flash settings I’m referring to on the OM-D E-M5 are found in Custom Menu F. Press the MENU button, scroll down to the Custom Menu (the cogs), press ► then scroll down to custom menu F and press ►. The first option in Custom Menu F is X-sync.

How do I adjust flash on Olympus E-M5?

To adjust the flash output, press the MODE button twice. The GN (guide number) number will flash. Turn the wheel to adjust the power output of the flash, then press OK. (Don’t ask me why you don’t use the Flash EV button for that.)

What should I do if my Olympus remote flash is not working?

if using Olympus RC mode, ensure it is configured correctly in camera and on the flash and that there is a master flash on the camera to command the remote flash if in doubt, change flash to manual mode, full output – if it is still too dark, either not enough flash output for settings and flash-subject distance, or, flash did not fire.