How do I fix code C0455?

Fix steering wheel position sensor connector an intermittent C0710, C0455 Service Stability condition. The advice is to remove the connector to the SWPS and use a nylon brush to apply dielectric grease to the terminals inside the connector and the SWPS.

What are the symptoms of a bad steering angle sensor?

Symptoms of a Bad or Failing Steering Angle Sensor

• Traction Control Light comes on. In most cases where an issue exists with the electronic stability program, an error code is triggered and stored inside the vehicle’s ECM.
• Steering wheel is loose and has “play”
• Car drives differently after a front end alignment.

What is a c0710 and c0455 trouble code?

GM has issued a service bulletin PI0639C to address a service stability message and trouble codes C0710 and C0455 for the vehicles listed below. In addition to the information in the service bulletin, I’m adding more information on how the system works along with additional tips on how to diagnose problems What is a C0710 and C0455 trouble code?

How much does it cost to fix a c0455 code?

The cost of diagnosing the C0455 code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. The Electronic Brake Control Module (EBCM) receives several inputs from the steering wheel position sensor.

What to do about service stability c0710 c0455?

If all those items check out, proceed with the recommended GM fix. an intermittent C0710, C0455 Service Stability condition. The advice is to remove the connector to the SWPS and use a nylon brush to apply dielectric grease to the terminals inside the connector and the SWPS.

What is the steering wheel position sensor?

A Critical Safety Component The Steering Angle Sensor is an important part of a vehicle’s safety system. It transmits the steering wheel’s rate of turn, wheel angle, and other important data to the specific vehicle’s computer. If there is a fault in the signal, the computer can disable the vehicle’s stability control.

How do you change a steering wheel position sensor on a Silverado?

Replacing the Sensor in 15 Easy Steps

1. Disconnect the negative battery cable.
2. Turn the wheel slightly to the left.
3. Locate the sensor.
4. Locate the bolt just under the sensor.
5. Using a socket, loosen, but do not remove the nut on the bolt.
6. With the steering wheel, position the front wheels straight ahead.

Where is the steering wheel position sensor located?

steering column
A steering position sensor (also called a steering angle sensor) may not be the most exciting part of a car, but along with brakes and the suspension system, it’s an important part as far as safety goes. It’s a donut-shaped sensor located in the steering column under the dash in GM vehicle.

What does code co561 mean?

Fix code C0561 traction control code This particular code is for GM and relates to the traction control system. The traction control system gets its data from the ABS system. The code means the EBCM is receiving faulty data from other modules or is faulty itself.

Can you bypass steering angle sensor?

Another Option – Bypass the EVO This means a steering position sensor will no longer be necessary, and you don’t need to replace it. Bypassing the EVO might be a good solution for your vehicle if you’re having chronic issues with the steering wheel position sensor or EVO in your vehicle.

Can Time Out steering angle sensor?

Today’s steering angle sensors are digital and are comprised of an LED light that measures the angle of the steering input. However, like any other sensor, the steering angle sensor can wear out or fail completely due to multiple factors beyond the control of most vehicle owners.