Are there different sizes of P traps?

When replacing a P-trap, you should use the same type of trap you remove. Traps come in 1- 1/4 inch (standard bathroom sink) or 1-1/2 inch (standard kitchen sink) inside diameter sizes. Be sure to check so you get the right size replacement at your local store.

What is the correct way to clear the blockage in the P-trap?

In the case of a clogged P-trap, it is best to place a small bucket under the trap with the water shut off. Using a large wench, the nut on the base of the trap should be loosened in order to disassemble the P-trap. Once the P-trap has been removed, the scum and dirt inside can be cleaned and-or removed.

Why do plumbers call it a P-trap?

The piece of plumbing is also called a p-trap because the curve and the long extension that goes into the wall makes the part resemble the letter P. The reason for the plumbing trap is to create a barrier in the drainpipe that prevents sewer gas from rising back up through the drain and into the house.

Do cleanouts have P traps?

(1) Location of cleanout fittings. (i) Cleanouts shall be installed if the drainage system cannot be cleaned through fixtures, drains, or vents. (iii) A cleaning tool shall not be required to pass through more than 360 degrees of fittings, excluding removable “P” traps, to reach any part of the drainage system.

What kind of brass is a chrome P trap?

Brass 1-1/4″ x 1-1/4″ Chrome P-Trap This OS&B P-Trap is CSA Certified and is constructed of high quality 20 gauge Brass and features a durable Chrome Plated finish. Brass 1-1/4″ x 1-1/4″ Chrome P-Trap is rated 5.0 out of 5 by 1 . Rated 5 out of 5 by FixitifIcanguy from Good stuff! Needed a trap in an emergency.

How to contact OS & B brass P trap?

Call 1-877-314-6040 for complete warranty details and installation enquiries. Brass 1-1/4″ x 1-1/4″ Chrome P-Trap This OS&B P-Trap is CSA Certified and is constructed of high quality 20 gauge Brass and features a durable Chrome Plated finish. Brass 1-1/4″ x 1-1/4″ Chrome P-Trap is rated 5.0 out of 5 by 1 .

What kind of P trap do I need for kitchen sink?

Slip joint design makes it easy to create a watertight seal on to p-trap. 1-1/4 in. in Semi-Cast Brass P-trap is designed for installation in commercial drain applications. Available in various length sizes. Included are brass or zinc nuts.