Where do the batteries go on a Vulcan EBF-25?
Where do the batteries go on a Vulcan EBF-25?
- Step 1 Bottoms up. Turn the Nerf Vulcan EBF-25 so the bottom side is facing up.
- Step 2 Find the button. Locate the orange section with the round button-looking thing.
- Step 3 Find the screw. Locate the metal screw behind this section.
- Step 4 Unscrew.
- Step 5 Lift off.
- Step 6 Battery tray.
- Step 7 Remove/replace.
- Step 8 Reinsert.
What type of batteries does a Nerf Vulcan take?
Product information
| Product Dimensions | 5.63 x 30.12 x 14.02 inches |
|---|---|
| Item model number | 25264 |
| Manufacturer recommended age | 8 years and up |
| Batteries | 6 C batteries required. |
| Best Sellers Rank | #260,695 in Toys & Games (See Top 100 in Toys & Games) #604 in Toy Foam Blasters |
How many batteries do you need for Nerf Vulcan?
Faster motor means more rounds down range, or into a co-workers face, as the case may be. The Nerf Vulcan EBF-25 starts with a requirement for 6 D-Cell batteries. That’s an expensive number of big cells. When wired, they yield about 9v. To connect the battery packs to the gun, we actually had to make a little tool.
Where is the battery tray on Nerf Vulcan ebf-25?
The battery tray in the Nerf Vulcan EBF-25 is somewhat hidden, if you don’t know where to look for it. It turns out the tray is easily removable once a single metal screw has been removed. Once that screw is loosened properly, the battery cover panel will remove easily and the battery tray will slide out without resistance.
Where is the ammo box on a Vulcan ebf-25?
Snap the ammo box onto the latch on the left-hand side of the Vulcan EBF-25 with the breech cover in the up position. Open the breech cover once you have snapped it on. Slip the Nerf darts into the bandolier and then connect the dummy cartridge on the bandolier into the feeding gear’s notch.
How does a Nerf EBF 25 N Strike work?
The Nerf EBF-25 N-Strike is equipped with a folding tripod and an ammo-feed box that holds up to 25 darts. Slip the carry handle into place on each side of the upper-middle section of the body of the blaster through the two holes and then slip the barrel tip through the barrel end of the blaster with the T-shape pointing up.