Do you need a kickdown cable on a Turbo 350?
Do you need a kickdown cable on a Turbo 350?
On a 350, it’s just a kick down cable, no problems. One an 700R4, it’s a throttle position cable and if it’s not hooked up it will burn up the transmission.
How do you install a transmission kickdown cable?
Method 1 of 1: Replacing the kickdown cable
- Materials Needed.
- Step 1: Jack up the front of the vehicle and set the jack stands.
- Step 2: Place wheel chocks on the rear wheels.
- Step 3: Disconnect the kickdown cable at the carburetor or throttle body.
- Step 4: Remove the kickdown cable from the mounting bracket.
How does a Turbo 350 kickdown cable work?
The kickdown function of General Motors vehicles equipped with the Turbo 350 automatic transmission is perhaps better known as “passing gear.” As the accelerator is depressed, the throttle lever on the engine is drawn back by a cable, which in turn pulls another cable attached to the transmission, causing it to …
How does the kickdown work on a Turbo 350?
The kickdown function of General Motors vehicles equipped with the Turbo 350 automatic transmission is perhaps better known as “passing gear.”. As the accelerator is depressed, the throttle lever on the engine is drawn back by a cable, which in turn pulls another cable attached to the transmission, causing it to downshift into a lower gear.
How does the kick down Cable TH350 work?
According to the service manual, the TH350 detent (kickdown) cable connects to both a detent valve and a detent pressure regulator inside the valve body. In addition to downshifting, it also increases the line pressure that’s applied to the clutches. That increased pressure helps prevent the clutches from slipping.
How do you install a kickdown cable on a GM Truck?
Leave the kickdown mounting bracket on the kickdown cable adjuster. Remove the inner wire from the cable housing. Step 2:From the engine end of the kickdown cable housing, install the tube hold down clip onto the cable housing with the lip pointed downwards, and slide it down to the trans tube at the end of the cable housing.
How do you hook up kick down Cable?
The lower end of the cable has a small tab on the end with a tiny hole in it. The linkage “rod” from the transmission is basically a stiff wire with a zig-zag bend in the end. Once you remove the small bolt that secures the cable jacket to the transmission case, you can pull the jacket out away from the case.