Can you use solder on brass?

Solder adheres as well to brass as it does to copper, so the fittings are usually molded with slip joints so you can solder them to the pipes. Spread soldering flux on the outside of the pipe and the inside of the brass fitting with a small brush.

What is the best solder to use for brass?

If you have done any electronic soldering you probably used a lead based solder. This is fine for soldering electronic components together but isn’t really strong enough, nor does it give a great bond, to copper and brass. Your best option is to use a silver solder.

Which solder is used in soldering of brass sheets?

Tix is a soft solder with a low melting point. This is important because high temperatures can cause the brass to discolor or become soft via process called annealing. There are some general principles that apply to almost every type of soldering.

What are some tips for soldering brass?

it is first necessary to clean both pieces thoroughly.

What is the best solder for brass?

The usual solder for brass is industrial quality silver solder; higher silver content. It does the soldering job fine, but the colour match is poor. very good colour match, much better than normal silver solder. 610-670C (1130-1238F) and it contains Cd.

How do you remove solder from brass?

Removing Excess Solder. If there are any clusters or solder drips on the brass, use solder wick to absorb them. Heat the excess solder until it is just starting to melt and then place a piece of solder wick over it, and the wick will absorb the unwanted run.

Does solder stick to brass?

Two answers here: Silver solder will stick to both brass and steel. Clean the two pieces to be joined with sandpaper. Brazing is stronger and less expensive than silver soldering. As above, but requires an oxy-acetylene torch and apply flux to the brass rod instead of the joint.