Where do the wires go on a starter motor?

The negative (ground) cable connects the negative “-” battery terminal to the engine cylinder block, or transmission, close to the starter. The positive cable connects the positive “+” battery terminal to the starter solenoid.

What are the wires called that connect to the starter?

The wire from the solenoid to the starter is called the main positive starter cable.

How many wires are connected to the starter motor?

To start and run a vintage car, you need only four wires—three for the starter and one for the coil. To recap: Thick, red wire from battery positive to threaded post on the starter motor. It can be a jumper cable, but if you need to move the car, a secured battery cable is much better.

What kind of wire does a mini starter use?

A mini starter operates differently. It will have a two-wire hookup and a solenoid on it. One large wire and one small wire. It gets wired differently. The large starter cable gets put on the same post as the positive battery cable and the small signal wire goes where the large cable was.

How does the starter motor work on a mini?

I’ve got a mini for circuit racing for one of the kids, and whilst out having some driving lessons in a local field at the weekend the starter motor has stopped working. The battery cable connects direct to one side of the starter, and a second wire runs from a push start in the car onto a large connector.

Where is the solenoid on a mini starter?

It will have a two-wire hookup and a solenoid on it. One large wire and one small wire. It gets wired differently. The large starter cable gets put on the same post as the positive battery cable and the small signal wire goes where the large cable was. This will bypass the solenoid on the apron and use the one on the mini-starter.

How do you hook up a Powerlite starter?

Most pre-engaged starter motors have a main power feed connection and a solenoid trigger connection. 1. Remove all wiring from original unit. 3. If necessary remove the link wire on the Powerlite unit that is fitted between the stud and spade (or small stud) terminals 4. Fit the Powerlite unit to the car 5.