How do I reset my Garmin cadence sensor?

For conducting a Garmin speed cadence sensor reset first of all access main menu then further select settings go to Bike settings from the list that appears select your bike then select ANT +SPD/CAD further press reset button on GPC 10 allow the reset button to flash red and green light then select “yes” under the …

Why is my Garmin cadence sensor not working?

If your device will not connect to the speed and cadence sensors, you can try these tips. Rotate the crank arm or wheel two revolutions to wake up the sensor. The LED flashes green for five seconds to indicate activity. Remove the sensor from your Garmin device to retry the pairing process.

How do I connect my Garmin speed sensor?

Pairing the Speed Sensor With Your Smartphone

1. From the app store on your smartphone, install and open the Garmin Connect app.
2. Bring your smartphone within 3 m (10 ft.)
3. Rotate the wheel two revolutions to wake up the speed sensor.
4. Select an option to add the speed sensor to your Garmin Connect account:

Is Garmin Edge 500 ANT+ compatible?

Loaded with data, Edge 500 tracks your distance, speed, location and elevation with high sensitivity GPS. Add an ANT+® compatible heart rate monitor, speed/cadence sensor or compatible power meter for a finely-tuned analysis of your ride.

Where to place GSC 10 on Garmin Edge?

NOTE: If you do not have a GSC™ 10, you can skip this task. Both magnets must be aligned with their respective indication lines for the Edge ® to receive data. Place the GSC 10 on the rear chain stay (on the side opposite the drive train).

Can a spoke magnet face away from a GSC 10?

The spoke magnet can face away from the GSC 10 if there is not enough room between the sensor arm and the spoke. The spoke magnet must line up with the indication line on the sensor arm. Loosen the screw on the sensor arm. Move the sensor arm to within 5 mm of the spoke magnet.

What should torque be on Garmin Edge 810?

When everything is aligned and working correctly, tighten the cable ties, the sensor arm, and the spoke magnet. Garmin ® recommends that the torque is 1.9 to 2.4 lbf-in. (0.21 to 0.27 N-m) to ensure a water tight seal on the GSC 10 sensor arm.