How do you make a parallel circuit step by step?

Step-By-Step Procedure

1. Cut the wire into five parts.
2. Remove half a centimeter of insulation from both ends of the wires.
3. Attach a wire to the positive side of the dry cell and wound the other end to the left side of a light bulb.
4. Attach another wire to the negative side of the dry cell and connect it to the switch.

How to construct a series parallel circuit on a breadboard?

Suppose we wanted to construct the following series-parallel combination circuit on a breadboard: The recommended way to do so on a breadboard would be to arrange the resistors in approximately the same pattern as seen in the schematic, for ease of relation to the schematic.

How do you make a parallel circuit with aluminum foil?

To make a parallel circuit, first cut 2 8-inch and 2 4-inch strips of aluminum foil, each the width of a straw. Then, connect one 8-inch strip to the positive terminal of a 9-volt battery and the other to the negative terminal. Next, wrap the ends of the 4-inch strips around the 8-inch strip that’s attached to the positive terminal, putting

How are the holes in a breadboard used in a circuit?

Thus, when a wire or component lead is inserted into a hole on the breadboard, there are four more holes in that column providing potential connection points to other wires and/or component leads. The result is an extremely flexible platform for constructing temporary circuits.

How do you make a parallel circuit with a battery?

Connect the first of the conducting strips to the battery. You’re now ready to start hooking up your parallel circuit. Take one of the 8 in (20 cm) strips of foil and connect it to the positive terminal of the battery. Take the other 8 in (20 cm) strip and connect it to the negative terminal of the battery.