Is there a way to reset a Whirlpool washer?

How to Confirm You Have Reset Your Whirlpool Washing Machine. Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.

Why did my Whirlpool washer stop spinning?

If your Whirlpool Washer is not spinning the problem is almost always the lid switch. If the lid switch is bad you will not hear the motor running when in spin. To check the lid, first unplug the washer. If you do not have continuity; the lid switch is bad and needs replacing.

What do you do when your Whirlpool washer won’t spin?

As a safety feature, Whirlpool washers will not spin if the lid switch is not activated; ensure the lid is properly closed and, if it is and the spin cycle is still not activated, you may need to replace the lid switch.

How to troubleshoot a whirlpool washing machine problem?

Troubleshooting Guide Water will not enter washer. Broken wire in wiring harness. Check for broken wire. Water level too low. Water level switch. Check water level switch. Drive motor will not run. No electrical power. Check electrical power. Drive motor will not run. Power Cord. Check power cord.

How to clear system error code on Whirlpool washer?

System error code. Press POWER to cancel cycle and clear the code. Then press POWER and select DRAIN & SPIN if there is excessive water in the washer. If the code appears again, call for service.

What should I do if my whirlpool water valve is not working?

Move inlet hoses to prevent kinking. Plugged inlet hose screens. Remove screens from inlet hoses and clean. Water valve. Check water valve. Note: Do not tamper with screens.

How to check Whirlpool duet front loading washer?

Whirlpool Duet Front-Loading Washer Error Codes 1 Check the drain hose and make sure it is not plugged or kinked 2 Check the electrical connections at the pump and make sure the pump is running. 3 Check the drain pump filter for foreign objects 4 If the above does not correct the problem replace the pump