How do you wire a GFCI outlet with a switch?
How do you wire a GFCI outlet with a switch?
How do I wire a switch to control a GFCI Receptacle?
- Place the switch in the hot wire going to the “line” side of the GFCI outlet.
- Run the neutral wire uninterrupted to the “line” side of the GFCI outlet.
- Connect ground wires as usual, switch and outlet.
Can a light switch be GFCI protected?
Notice, GFCI protection is only required for receptacles. Whereas AFCI protection, is required for all outlets in the mentioned areas. So while the light switch doesn’t have to be GFCI protected, it does have to be AFCI protected.
Can lights be connected to GFCI?
Lights and fans above bathtub sunshowers are required to be GFCI protected. Only receptacle outlets are required to be GFCI protected, however, there is nothing prohibiting additional outlets (such as lighting outlets) from being protected.
Can an outlet be added from a light switch?
Adding an electrical outlet next to an existing light switch is easy, as long as there is a neutral wire in the box. If there is a bundle of two white wires tied together behind the switch and two separate wires running to the switch, it will be easy to add an outlet.
Can I control a GFCI outlet with a switch?
Connect the ground / earth terminal to the ground wire from the main board. This way, the outlet in the GFCI can be controlled (ON/OFF operation) through the switch in the GFCI combo. Switch off the main circuit breaker to make sure the power supply is OFF before wiring a GFCI outlet.
How do you install an electric light switch?
Install the new light switch. Connect the two white wires together by holding their stripped ends side by side and screwing on a wire nut. Connect the bare ground wires together in like manner. Push these wires in the box. Make loops on the ends of the two black wires. Connect them to the two terminals on the switch,…
What color wire goes on a light switch?
Basic Knowledge of How to Wire a Light Switch Black Wire – This is the hot or load wire White Wire – This is the neutral wire Bare Copper (Green) Wire – This is your ground wire Red Wire – This wire is used for 3 or 4 way switches and will connect the switches together so they can each control your lights.
What is a GFCI switch?
This page contains wiring diagrams for a ground fault circuit interrupter (gfci) with a built in switch, often called a gfci outlet switch combo. This device can be used for ground fault protection near water sources such as in a kitchen or bathroom where space is a minimum and both devices are needed.