Where is the hydraulic filter on a 3000 Ford tractor?

The rear of the tractor is toward the right, the upper arrow is for the outlet filter, and the lower arrow is for the intake filter.

How do you bleed a hydraulic pump on a Ford 3000?

There is a bleed plug on the body of the pump itself, you should loosen that plug, but not remove it, and bleed it there first until you have fluid and no bubbles, then tighten that plug down and loosen the plug on the test port of the blocking plate and bleed it there until there are no bubbles. That should do it.

Does a Ford 3000 tractor have a hydraulic filter?

Changing the hydraulic filter on your Ford 3000 Tractor can be challenging. However, once you get it done right, it won’t be a problem anymore the next time. First, pay attention to the suction and filter strainer. Make sure someone with experience is there to help you and will supervise as you work on your Ford 3000.

How do you check the hydraulic pressure on a 3000 Ford tractor?

Filler cap for the rear end is on top of the center housing, behind you right butt cheek as you are seated on your tractor. After checking fluid levels, get a 3000 psi pressure gauge and screw it into the test port on the hydraulic pump. Pump pressure should be about 2000-2500 psi. Post back and we will go from there.

How to fix hydraulic problems on a Ford 3000?

To repair your problem the lift cover will need to be removed from the tractor. Either the control linkage is damaged or came apart or the valve is stuck inside. To make it work properly after repairing it you really need a couple of special setting tools from the manufacturer.

What’s the problem with the lift on a Ford 3000?

Howdy Dexter, welcome back to the forum! First and easiest thing to check is if the position/draft control lever is “up” for lift position control. The down/horizontal position is for draft control (used primarily for plowing). Draft control causes strange hydraulic performance occasionally (the rod attached to the top link may be stuck).

Why is the hitch on my Ford 3000 not working?

3) Draft control or position control damaged. 4) Unload valve or back pressure valve faulty. 5) Lift piston seals damaged. 6) Unload valve plug worn. 7) Lift cylinder, lift cover, or pressure transfer tube cracked. Note that my manual is for a Ford 3600, so there may be some things that don’t apply to your 3000.

Which is the correct hydraulic pump for a Ford 3000?

The C5NN600A pump kit Yesterday’s Tractor sent you is the correct pump part number for a Ford 3000 tractor. Your hydraulic pump has been swapped out somewhere in its past, which is not uncommon. I would contact YT and explain your situation. They can probably cross-reference to find the correct kit for you.