Which is a type of Monmsg in CL?

The Monitor Message (MONMSG) command is used to monitor for escape, notify, or status messages that are sent to the call stack of the CL program or procedure in which the MONMSG command is used. Note: By using the code examples, you agree to the terms of the Code license and disclaimer information.

How to check objects in as400?

Object type (OBJTYPE) Specifies the object type of the object to be checked. To see a complete list of object types when prompting this command, position the cursor on the field for this parameter and press F4 (Prompt).

What is MONMSG in as400?

The Monitor Message (MONMSG) command is used to monitor escape, notify, and status messages sent to the program message queue of the program in which the command is used. The command monitors the messages for the condition specified by the comparison data given in the command.

What is CPF0000?

Monitors for every message with a generic message identifier that begins with a specific licensed program ( ppp ). For example, CPF0000 indicates that all notify, status, and escape messages beginning with CPF are monitored.

Where is the monmsg in the CL program?

The MONMSG is specified immediately following the last declared command in the CL program. It will catch all the error escape messages that exist in the program and doesn’t have satisfying command level MONMSG or doesn’t have any command level MONMSG. Here the MONMSG command immediately follows a CL command.

When to use the monmsg command in Ile?

The MONMSG command can be coded following most commands in a CL program or ILE CL procedure. A MONMSG command that is not placed at the beginning of the program applies only to the immediately preceding command; this is called a command-level MONMSG command. The command-level MONMSG command monitors only messages sent by the previous command.

What does the chkobj check object command do?

The Check Object (CHKOBJ) command checks object existence and verifies the user’s authority for the object before trying to access it. If the object exists and the user has the proper authority for the object, no error messages are sent to the user. For verification, as many as ten specific authorities can be specified on the command.

How does the message queue work in monmsg?

· The messages are sent to the program message queue for the conditions specified in the command. If condition exists, the CL command specified on the MONMSG command runs. · It doesn’t handle diagnostic messages but we can receive those messages from the message queue to get additional information related to the error.