How do I connect to Cisco WAP4410N?

To connect the Cisco WAP4410N to your network using a PoE switch or router, connect the Ethernet port of the access point to a PoE port on the PoE switch. The lights on the front panel light up as soon as the Cisco WAP4410N Access Point powers on.

How do I reset my Cisco WAP4410N router?

To reset the Cisco WAP4410N to its default settings, you have to do the following steps:

1. Turn on router.
2. Press Factory Reset button and hold for at least 15 seconds.
3. Device restarts automatically.
4. Default settings have been restored.

What is access Point mode?

Access point (AP) mode enables your router to function as a gateway for wireless devices to connect to. In AP mode, your NETGEAR router extends your existing WiFi instead of creating a new WiFi network. Note: Router features like DHCP and port forwarding are disabled while in AP mode.

Can a wap4410n be used as a wireless repeater?

Since a wap4410n has both a wired and wireless mac address, make sure you use the correct one when configuring the ap and repeater. All this being said, with the current firmware, a wap4410n acting as a repeater for a wap4410n ap will only work (semi) reliably for me with wep encryption.

How to install and configure Cisco wap4410n?

Connect your computer to the Cisco WAP4410N access point using a crossover cable and configure the following network address on your computer: • IP – 192.168.1.10 • MASK – 255.255.255.0 Turn on the WAP4410N and wait 1 minute.

How to enable wireless repeater on Cisco WAP?

Step 1. If you want the WAP’s wireless signal to be repeated by a wireless repeater, check the Allow wireless signal to be repeated by a repeater check box. Step 2. If you checked the Allow wireless signal to be repeated by a repeater check box, insert the MAC address (es) of the repeater (s) in the MAC 1 – 3 field (s).

Can a wired WAP connect to a wireless WAP?

• Wireless WDS Bridge — In this mode, a wireless bridge can be created between this WAP and another WDS access point; wireless clients cannot connect to the WAP in this mode. This option allows wired devices to connect to the network wirelessly. If you select this option, go to the Wireless WDS Bridge section.

https://www.youtube.com/watch?v=quaF-FQIlWs