Why am I getting CPU fan error if the fans are spinning?

What Causes CPU Fan Errors? A CPU fan error on start-up is typically due to physical damage to the fan, incorrect settings, or external factors causing the computer to overheat and force the fan to run at unusually high speeds. Dust or other objects obstructing the device’s air vents can also cause CPU fan errors.

Can CPU fans ignore error?

In BIOS, go to the Fan control section not the monitoring section. The CPU fan headers should be listed – should show “CPU Q-FAN Control – Enabled or Disabled”, Enable that setting. Then you will see the setting below that is “CPU Fan Speed Low Limit”, set that to Ignore.

What is PWM control on Antec Kuhler 920?

The 920 is the first cooler we’ve encountered that ships with fan control software. PWM control allows for lower fan speeds. Surely a must-have feature.

Where to install Antec H2O 920 liquid cooling system?

Be sure to connect the ATX 12 volt connector because you may not have access to it after the fans and radiator are installed. Install the first fan to the inside rear of the case making sure to observe the direction of air flow and the orientation of the wires that power the fan.

What kind of water cooler is Antec H20 620?

The Kühler H20 620 and 920 are self-contained liquid CPU cooling units from Antec (manufactured by Asetek). Hopefully they are improvements over the the first water cooler we reviewed, the Corsair Hydro H50, which was sunk for SPCR audiences by a noisy pump.

Are there any liquid cooling units from Antec?

Antec carries a few traditional heatsinks under the “Kühler” name (German for “cooler”) but they also have two self-contained liquid cooling units, the H20 620 and H20 920. They’re not the first to release such products, but it’s still a nice change from the countless tower heatsinks that we come across.