How much does it cost to Regear a Jeep JK?
How much does it cost to Regear a Jeep JK?
Depending on your type of Jeep, what you want to be done, and where you get it done, it will cost anywhere from $1,200 on the low end to $3,000 on the high end. This price range typically includes parts and labor done by a professional.
Should I Regear with 33s?
You don’t need to regear with just 33’s. Most likely, the reason behind you ‘drag’ is the width of the tires. You sure won’t be turning them over any time soon. The regearing won’t do damage or harm to the jeep, but it ‘may’ void your warranty on the axles.
How hard is it to Regear a Jeep JK?
Though regearing is a relatively simple process, doing it incorrectly can mess up your Jeep and your day. Front and rear axles need to be regeared simultaneously. The hardest part for a lot of Jeep enthusiasts is giving the new gears time to break in. You’ll want to drive for about 500 miles to break them in.
Do I need to Regear my Jeep with 33s?
How long does it take to Regear a Jeep?
How long does it take to Regear a Jeep? This depends on if you’re doing a full install or just getting an axle and new ring & pinion. In general, you can expect a full install to take 3-5 days. However, most shops will try to get the vehicle out in 1-2 days (some try even harder but this usually isn’t realistic.)
What is a good gear ratio for 35 inch tires?
Gear Ratio And Tire Size Calculator
| 3.31 | 4.56 | |
|---|---|---|
| 34″ | 2126 | 2929 |
| 35″ | 2065 | 2845 |
| 36″ | 2008 | 2766 |
| 37″ | 1954 | 2692 |
How do I Regear my Jeep JK?
How to Regear Your Jeep
- Drain the differential’s gear oil.
- Remove the axle shafts.
- If you’re not replacing the main caps, mark them so you know which side they came from.
- Clean all new parts and remove any metal shaving within the carrier.
- Coat all new bearings and seals with fresh gear oil.
Can you run 37s on stock axles?
You can for sure run 37’s on a D30. Weld on some C-Gussets at least and re-gear to 4.56 or 4.88 and you’ll be good. The weak point is the C’s but once gusseted, you will be good. The next weak point will be the axle shafts, keep those stock to remain the weak point.
Can you put 37 on a Jeep?
So can you get 37 inch tires on your Jeep? Yes you can, if you make a plan ahead of time.
What gear ratio do I need for 33 inch tires?
Gear Ratio And Tire Size Calculator
| 3.31 | 4.56 | |
|---|---|---|
| 33″ | 2191 | 3018 |
| 34″ | 2126 | 2929 |
| 35″ | 2065 | 2845 |
| 36″ | 2008 | 2766 |
How much does it cost to Regear axles?
Some places charge $150/hour for labor. Find a local shop that charges $75 or so. $1500–maybe a little more–for all of that work. You should be able to find a quote in the $1200 range, but then they ask, “You don’t really want to keep them old bearings in there, do you?” That bumps it up into the $1500-1700 range.
What gear ratio do I need in my Jeep?
When looking for a professional to help re-gear your Jeep, make sure they replace both the front and rear axles of your Jeep with premium quality gears. Typical new gear ratios are 4.10:1, 4.56:1, 4.88:1, or 5.13:1. Services should also include the following: Front and rear ring and pinions with master install kits.
What does it mean to regear a Jeep Wrangler?
Regearing refers to the process of changing your pinion gears and ring gears to a different ratio, which changes the balance of torque and speed. Regearing your Jeep is a crucial step in adjusting the size of your tires, since improper gearing can result in more stress being transferred to the axle.
What do I need to regear my Jeep?
Our regears come with new Ring & Pinions and MASTER install kits from either Yukon Gear & Axle or Revolution Gear & Axle. Master Install kits come with carrier and pinion bearings (Timken and/or Koyo), all necessary shims, new crush washers, and hardware. All fluids included – even the fluid after completion of a successful break-in procedure!
What should I change in my Jeep Wrangler?
Depending on how you use your Jeep, you may want to consider changing out your differential’s ring and pinion gears for a set more appropriate to your build. Whether you need the MPGs or the horsepower, and new set of gears can change the attitude of your rig.
What’s the difference between regear and DIY regear?
– Vacation day 1: regear. – Vacation day 2: plan to tear some $h*t up. @JLRubiMD I found these the other day, if you are planning to go after your gears yourself they should prove useful. We charge significantly less and include a 500 mile gear oil change. I don’t want to speak on their behalf but we do these in a couple hours.