Articles

How do I reset my UPS battery?

by Rhyley Bryan

How do I reset my UPS battery?

How to Discharge (Brain Dead) a Back-UPS

  1. Disconnect any attached load. (
  2. Unplug the UPS from the wall socket.
  3. Disconnect the UPS’ internal battery. (
  4. Push and hold the “On” button on the UPS for 5 seconds (you might hear a click, chirp or lights will blink)
  5. Reconnect internal battery.
  6. Plug UPS in wall socket.

What to do when UPS is not turning on?

The UPS is not connected to utility power. Be sure that the power cable is securely connected to the unit and to the utility power supply. The input circuit breaker has tripped. Reduce the load to the UPS, disconnect nonessential equipment and reset the circuit breaker.

How do I know if UPS is working?

To perform a UPS diagnostic test

  1. On the Diagnostics menu, click Test Hardware.
  2. Click the System Test or Battery Test tab.
  3. Click Test….
  4. At any time during the test or after the test is performed, click the Results button to update the result field.
  5. The status of the procedure is shown in the status column.

Why my UPS is not working?

Be sure the line cord is connected. Be sure each circuit breaker is in the On position, or replace the fuse if needed. If this occurs repeatedly, contact an authorized service provider. Check the UPS LEDs to be sure a battery or site wiring problem has not occurred.

How do you fix a dead up battery at home?

Instructions:

  1. Take about 2 cups of distilled water and add 2/3 cup of Epsom salt which is easily available in chemist shops.
  2. Heat the solution until the Epsom salt is totally dissolved in the water.
  3. Carefully open the filler caps of the battery.

Can we repair UPS battery?

You can repair your computer UPS yourself . Usually the lifetime for any UPS is one or two years. Most of the time an UPS battery gets damaged after this period. The UPS is OK, concentrate on the battery .

How do I reset my AP9617 to factory settings?

Press CTRL+C, log off, reconnect any serial cable you disconnected, and restart any service you disabled. AP9617 includes Status LEDs, a Reset button, and a 10/100Base-T connector.

How do you do a cold start and brain dead on Smart UPS?

The Brain Dead procedure performs a hard reset of the Smart-Ups microprocessor….Cold Start:

  1. Turn off and unplug the Smart-UPS from wall.
  2. Press and hold the power button (labeled “”I/TEST”” on legacy non-LCD screen units) on the front of the UPS until you hear a LONG beep.
  3. Let go DURING the long beep.