Why is my Jeep Grand Cherokee cranking but not starting?

The most common causes that hinders normal starting operation of your Grand Cherokee are dead key fob battery, dead 12v battery, corrosion on battery terminals, bad alternator, clogged fuel filter, broken starter, blown fuse, empty gas tank, immobilizer error or any fault in the electrical system.

How do you diagnose crank no start?

Rapid No-Start Diagnosis

1. Identification. Identifying the possible causes of a no-start at the outset can shorten the diagnostic time.
2. Cranking. All good diagnostics start at the beginning, and the beginning of a no-start diagnosis is always the cranking circuit.
3. Spark.
4. Timing.
5. Fuel.
6. Compression.
7. Theft-Deterrent Systems.

What sensor would stop a car from starting?

Which sensors prevent the engine from starting? Faulty sensors can keep your engine from starting as a safety measure. For instance, the crank angle sensor, or crankshaft position sensor, may be located near the transmission belt housing and come in contact with water, which would prevent it from working.

Why is my jeep not starting?

If your Jeep won’t start and you simply hear one click, then you could have a faulty starter motor. The solenoid could have enough power to engage and feed current to the starter, but a loss of current in the ground cable or faulty battery could be causing the starter to not crank properly.

Why does my jeep have a hard time starting?

When the check valve leaks, it instead lets the fuel drain back down out of the fuel injector/fuel rail area and back into the fuel tank. When that happens, it take quite a while for the fuel pump to get the fuel back up from the gas tank to the fuel rail which is what causes the slow start.

Will a crankshaft position sensor stop a car from starting?

Issues starting the vehicle The most common symptom associated with a bad or failing crankshaft position sensor is difficulty starting the vehicle. If the crankshaft position sensor is having a problem, the vehicle may have intermittent starting issues or may not start at all.

Why did my 1996 Jeep turn over but not start?

1996 Jeep turns over but will not start. I checked the spark plugs and there is no spark. Changed rotor, distributor Jeep Cherokee: 1996 Jeep turns over but will not start.

What causes a jeep to have a no start condition?

The usual suspects, that can cause this type of problem, are a bad fuel pump, bad crank sensor, bad ignition coil (if your Jeep is distributor equipped), etc. Does Not Crank Condition: Means that the engine is not cranking when you turn the key to crank the engine.

What should I do if my Jeep Cherokee turns over?

Jeep Cherokee: 1996 Jeep turns over but will not start. I… Experience: ASE certified Technician advanced level specialist. Wisconsin certified emissions state inspector Hello! My name is XXXXX XXXXX I can assist you with your question.

What does it mean when your Honda Civic won’t start?

Does Not Crank Condition: Means that the engine is not cranking when you turn the key to crank the engine. In other words, the engine doesn’t turn over at all. This is usually due to a bad starter motor, bad ignition switch, bad neutral safety switch, or the engine is locked up.