How do I reset my Panasonic DVD recorder?

Reset the unit as follows:

1. Press the [POWER] button on the DVD player to turn it on.
2. Press the [OPEN/CLOSE] button to open the disc tray.
3. Press the number button “ 5 ” on the remote control 4 times. (The power is automatically turned off.) All the settings return to the factory preset.

Why is my Panasonic DVD player in black and white?

Make sure the AV input on the TV is set to accept the correct signal type from the DVD Recorder: – RGB (automatically detected by the TV), S-Video or Video. Consult the TV instructions for setting the correct AV input signal type.

How do I reset my Panasonic DMR ez48v?

Pressing the power button for 10 sec turns it off and displays the time. When the power button is pressed again, it does the 15 HELLOs, etc. When the small reset button is pushed with a pen tip, it shows one zero, then 2, 3, 4, 5, 6 zeroes and then backwards to none.

How do I restore my Panasonic DVR to factory settings?

To perform a factory reset, do the following:

1. Power the camera.
2. Using a paper-clip or suitably pointed object, press the factory reset button and hold for 1 second.
3. The LED on the front of the camera will flash red, then go off, then flash red for a few times as it resets and reboots itself.

How do you reset the child lock on a Panasonic TV?

Press and hold the REC and PLAY buttons on the front of the unit together for 5 seconds until the display shows INIT. Confirm that the front display shows ‘INIT’. The parental PIN code has now been reset to the default code of ‘0000’.

How do I reset a DVD recorder?

On the DVD remote control, press the UP ARROW or DOWN ARROW button to select the SETUP icon. Press the ENTER button. Press the UP ARROW or DOWN ARROW button to select RESET . Press the ENTER button.

Why does my DVD not play in color?

Make sure the disc player is properly connected. IMPORTANT: The disc player should be connected directly to a TV or Audio/Video (A/V) receiver. If using A/V cables, check that the red, white, and yellow plugs are securely connected to the same colored jacks on both the disc player and TV (or A/V receiver).

How do I change the color of my DVD player?

Make sure the cables are connected to the same colour cables are connected on both sides. Yellow to yellow, red to red and white to white in the case of a composite or RCA cable . If you’re using a component connection make sure the red, green and blue cables are paired with the DVD player and TV set.

How do you fix a DVD player error?

Remove the disc from the DVD player. Use a lint-free cloth and some denatured alcohol or water to clean the disc and remove any dust or smudges that may prevent the player from reading it properly. Reinsert the disc into the player and press “Play” to see if cleaning the disc fixes the “NO DISC” error.