How do you reset the ABS light on a Dodge Caravan?

You can reset the “ABS” fault light by using a diagnostic scan tool, or by unhooking the van’s battery.

1. Turn the Town and Country’s engine off, but leave the key in the “On” position.
2. Plug your diagnostic scan tool into the scan port beneath the steering column.
3. Push the “Reset” or “Clear” button on your scan tool.

What does the ABS light mean on a Dodge Caravan?

As the wheel speed sensor is located very close to the braking system, the high heat generated by the brakes cause the wheel speed sensor to be more susceptible to damage. This in turn makes it one of the more common causes of the ABS light coming on.

How do I reset my ABS light without a scanner?

How to Reset ABS Light Without a Scan Tool (Hard Reset)

1. Get a Jumper Wire. First off, go out and buy a jumper wire.
2. Locate the DLC. Once you have the fused jumper wire or service connector adapter kit, you can find the DLC connectors.
3. Connect the Jumper to the DLC.
4. Reset the ABS System.

Can AutoZone scan ABS codes?

It Might Be the ABS Unfortunately, the only way to check whether or not the problem is with the ABS is to go and get the codes of your car read. AutoZone can scan your codes as part of our Fix Finder service, or you can do it yourself if you already have a scan tool.

Can worn brake pads cause ABS light to come on?

To Be Clear, Worn Brakes CAN Cause The ABS Light To Come On, But It’s Not Why You Think. Your ABS system has its own electrical control unit which is separate from your braking system, even though the ABS and your brakes work together. In about 90% of cases, your ABS light is not caused by worn brake pads.

How much does it cost to fix the ABS system?

How Much Will An ABS Control Module Repair Cost? An ABS control module replacement can range from $320 to over $1,000. The wide price range isn’t really driven by labor cost, which will typically be around $80-$120. It depends on how much the control module costs and how difficult it is to source.

What does the ABS light on a Dodge Grand Caravan mean?

ABS is the short form for the ‘Anti-lock Brake Skid’ safety control system. It is also commonly referred to as the anti-lock braking system. The ABS light gets turned on whenever there is a problem with the system to let the driver know that the system has been disabled.

Where are the sensors on a Dodge Grand Caravan?

These sensors are located near the wheel itself. The computer signals the valve to drop the brake line pressure if it seems that the rotational speed of one or more wheels is lesser than the others. The computer then helps the pump maintain the pressure to allow the wheel or the wheels to start rolling once more.

Where is the ABS fuse on a Dodge Caravan?

Open the van’s hood. Find the power integration module in the rear section (closest to the windshield) of the engine bay on the driver’s side. This is a black box. It’s right next to the van’s battery. Lift the box’s lid to reveal the fuses. Find the fuse in compartment F9. This is a green fuse. It is for the ABS pump.

How to disconnect the battery on a Dodge Grand Caravan?

Disconnecting the battery can be done even if the driver is a complete and utter novice at car maintenance as all that’s needed is a little knowhow and an adjustable wrench to deal with any troublesome bolts. Start by opening up the hood of the vehicle and making sure that it’s secured.