How do I know if my washing machine drain pump is bad?

Check the pump pulley by removing the pump from the washer and trying to rotate it by hand. If the pulley doesn’t turn freely and is frozen or stiff, replace it. Also, if the agitator is moving but the tub isn’t, this is a sign the pump is dying. For front-loading washers, do not attempt to open the door mid-cycle.

How do you force a Kenmore washer to drain?

Squeeze the locking pin on the end of the drain hose that is connected to the back of the washer if you will be draining the water into a floor drain. Pull the hose away from the washer to disconnect it. The water will pour out as soon as the hose is disconnected.

Why won’t my Kenmore washer drain?

If the washer won’t drain there might be a clogged pump or hose. It’s common for small socks or other small clothing items to get into the water drain system and clog the hose leading to the pump or the pump itself. Remove the hoses from the pump in order to remove the article of clothing.

How do you fix a Kenmore washer that won’t drain or spin?

What to Do When Your Washing Machine Won’t Drain

1. Perform a Master Reset. Unplug your washer for about one minute.
2. Test the Lid Switch Assembly.
3. See if the Drain Hose is Kinked.
4. Check the Drain Hose or Pump for Clogs.
5. Clean out the Coin Trap.
6. Check the Water Level Control.
7. Schedule Washing Machine Repair.

Why is my washer not spinning or draining?

Washing machine not draining? If the washer won’t drain or spin, either something is stuck in the washing machine drain hose or pump, or the pump is broken. If a washer won’t drain or spin, the fix is simple if you’re even just a little bit handy with tools.

How many ohms should a washer drain pump have?

The reading should be between 5 ohms to 10 ohms depending upon your washer model. A reading of zero or infinity, means the pump requires replacement.

How do you know if your washing machine drain hose is clogged?

Observe the washing machine as it pumps water into the hoses and up into the standpipe. If you see water back up and out of the standpipe, your washer’s drain is most likely the issue. The amount of time it takes for the standpipe to fill up and overflow helps you diagnose where the clog is located.