Can I use flexible pipe for sink drain?

Flexible drain parts can be used to quickly connect offset sink drains. If you have ever been a little short on pipe or had drain trap fittings that were just shy of the necessary length or angle, you’ll appreciate the usefulness of flexible drain parts.

Does p-trap have to be directly below drain?

You attach the p-trap directly to the drainage and manuever the p-traps exits into you existing drain. It is not ideal to have the p-trap below the the exit drain because water gravity has to force the water out instead of it flowing downwards naturally.

Why are flexible P traps bad?

P-traps take on and maintain the shape of a letter p to keep sewer gases out of your house. When you use a flexible p trap, you’re more likely to get the shape wrong, and you’re more likely to accidentally misshape it when you bump the pipe. Or when you bump it, the force might cause it to spring a leak.

What is the difference between a J bend and a P-trap?

The J-bend beneath the sink is also referred to as the P-trap, the U-bend and sometimes even just the drain trap. In some cases, however, hand-tightening may not seat the washer correctly, particularly if your drain pipes are metal, so slip-joint pliers will often come in handy.

Why does my P trap smell?

A P-trap is the curved portion of pipe under the sink. It’s supposed to create a seal by holding water, which prevents sewer gases from getting into the bathroom. If the P-trap isn’t working properly, sewer gasses can make their way into the bathroom and cause your sink to stink.

How far below drain should P trap be?

24 inches
However, the Universal Plumbing Code stipulates that the total developed length of all tailpieces, arms and fittings connecting the drain to the p-trap must be 24 inches or less.

Do flexible P traps work?

What is the difference between a J bend and a P trap?

Can P-trap installed backwards?

The outlet end of the trap pipe should be lower than the inlet when installed properly. The example shown has it backward, which creates a trap seal more than 4” and makes the drain more likely to clog—and that’s a long explanation for why a backwards trap is a bad thing.

How do you install a P trap?

Follow these steps to install the P-trap: Slide the short side of the P-trap onto the tailpiece that drops down from the sink drain. Move the P-trap up or down to align the trap arm with the opening in the wall. Use a hacksaw to cut the tailpiece if you can’t move the P-trap higher up the tailpiece and the trap arm is below the wall drain fitting.

What are the components of a P trap?

The components of a sink P trap. A new P trap assembly usually comes with a tailpiece, a trap adapter to connect the curved pipe to tailpiece, u-shaped pipe with clean-out access, and a trap arm.

What is a condensate P trap?

The p-trap traps condensate (water) so that air cannot pass through. Because the coil is under positive pressure when the system is running, air would rush right out of the condensate lines. The p-trap helps prevent this.

What is the height of a P trap?

The important dimensions for a P-Trap are… That the exit point of the trap is 4 to 6 inches lower than the entrance point. The overall height of the trap should be 8 to 12 inches, and the distance between the two sides of the trap should be 4 to 6 inches.