How do you program the TPMS on a 2007 Silverado?

To reset the system, first make sure the tire pressures are correct. Turn the engine on, then press and hold the reset button. You’ll find it low and to the right of the steering wheel on the instrument panel. Hold the button down until the TPMS indicator light in the instrument panel blinks slowly 3 three times.

Where is the TPMS reset button on a 2007 Chevy Silverado?

Alternatively, if your Silverado does not have keyless entry, press and release the “Info” button on the driver’s information center until “Tire Learn” appears on the DIC display. Press and hold the “Set/Reset” button. Listen for a double horn chirp, indicating entry into the TPM learn mode.

How do I relearn my tire pressure sensor Chevy?

Turn your vehicle’s key to the “On” position without starting the vehicle. Push the TPMS reset button until the tire pressure light flashes three times, then let go. Start the car and wait for about 20 minutes for the tire pressure sensor to refresh.

How do you program the TPMS sensor on a 2008 Silverado?

Chevrolet Silverado (2008 – 2012) TPMS Reset Procedure

1. Apply parking brake.
2. Press and hold unlock and lock buttons on the keyless entry transmitter until horn sounds, and then LF turn signal will become illuminated.
3. Starting with LF tire, increase/decrease tire pressure until horn sounds.

How do I reset my TPMS on my Silverado?

Turn vehicle to ON/RUN. Push the trip odometer reset stem until Tire Pressure is displayed. Push and hold trip reset stem to begin the sensor matching process. Push trip reset again to confirm.

Can I reset the TPMS by disconnecting the battery?

Find the battery and disconnect the negative battery cable. You will need a wrench to do this. Once the battery is disconnected, turn your vehicle on and press the horn for approximately three seconds. This will drain any remaining energy stored in the vehicle’s electrical system.

Where is the reset button for the TPMS?

steering wheel
The TPMS reset button is usually located beneath the steering wheel. If you are unable to find it, refer to your vehicle’s owner’s manual. Inflate all tires to 3 PSI over their recommended amount, then deflate them completely. Be sure to include the spare tire, as it may have a sensor as well.

How to reset the TPMs on a 2007 Chevy Silverado?

There are two reset procedures for the 2007 Silverado’s TPMS. The first, and most common, procedure is to adjust the tire pressure if it is low. The second procedure is to relearn the position of each sensor, which you only need to do if you have rotated the tires or replaced a sensor.

How to relearn the GM TPMS setup procedure?

Place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor. A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position. Proceed to the passenger side front tire, and repeat the procedure in Step 8.

How to reset tire pressure sensor TPMS light on Chevrolet?

Just like the previous model, you’ll need TPMS Relearn Tool to reset the Tire Pressure Monitoring System in this latest Suburban model year. Here’s how to do it: Start from the driver side front tire, place the TPMS Relearn Tool against the tire sidewall, near the valve stem.

When did they start using TPMs on cars?

Starting in 2007, most vehicles use a TRW-, Schrader- or VDO-manufactured system that all share the same relearn procedures and behaviors, with only a few exceptions (like the Pontiac Vibe). Shops should use a TPMS tool to reset the sensor positions after rotation.