What does po345 mean?

Camshaft Position Sensor A Circuit Malfunction
P0345 is a diagnostic trouble code (DTC) for “Camshaft Position Sensor A Circuit Malfunction (Bank 2)”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.

What does camshaft position sensor A circuit Bank 2 mean?

Diagnostic trouble code (DTC) P0345 stands for “Camshaft Position Sensor “A” Circuit (Bank 2).” This code refers to an issue in the camshaft position sensor (CMP) circuit of the engine’s bank 2, which is the bank not containing cylinder #1.

What causes a camshaft sensor code?

What are the Possible Causes of the P0340 Code? The most common causes behind the disruption of the signal from the camshaft position sensor to the PCM include: Failing or defective camshaft position sensor. Circuit problems (e.g., damaged wiring, loose connections)

What causes a P0018 code?

What causes the P0018 code? The bank 2 intake camshaft is out of position compared to the crankshaft position. The bank 2 camshaft phaser is stuck in one position or will not move. The phaser is not getting oil because the oil viscosity being used in the engine is too thick.

Where is sensor a bank 2?

These two sensors each read an individual reluctor or tone ring. For the CKP, this ring is usually mounted on the crankshaft or on the harmonic balancer. For the CMP, this ring is located on the camshaft itself, or the camshaft sprocket.

What is the code for a bad camshaft sensor?

P0340 is a diagnostic trouble code (DTC) for “Camshaft Position Sensor Circuit Malfunction”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.

Where is bank 2 sensor A?

What causes the p0345 code on a Ford F150?

As stated above, the P0345 code is often caused by a failure in the Camshaft Position Sensor itself. Here are the most common causes: Wiring Issue – The Camshaft Position Sensor wiring is exposed to harsher conditions than a lot of the wiring in your F150.

What to do if your camshaft position sensor says p0345?

Visually inspect the camshaft position sensor connector in search of corroded or broken connectors. Make any other repairs (if other codes are present) to make sure that other codes are not sources of the trouble code P0345. Check your camshaft position sensor’s voltage, ground, and signal readings with a multimeter.

When do I get p0345 and P0 345?

Please log in or register to add a comment. Please log in or register to answer this question. P0349 and P0345 When these appear the charging system needs to be checked, This is a very popular code symptom where the alternator diode or open phase connector causes these code to appear.TSB # 06-09-12.

What’s the p0345 code on a pathfinder?

Nissan adam 2006 4.0 pathfinder 89000 miles I am back -after a new timing chain and tensioners and timing solenoids -all new gallery gaskets . and all 3 sensors changed out .the p0011 and p0021 codes are gone ..today the car died again . stalled just as before . this time I am getting p0345 . we Need more help with a p0345 code?