What psi should my FOX shock be?

Add air pressure to the main air chamber in ~50 psi (3.4 bar) increments, slowly cycling the shock after every 50 psi (3.4 bar) addition. Set your main air chamber to between 50-300psi to prepare to set sag as described in the “Setting Shock Air Pressure” section below.

What pressure should mountain bike shocks be at?

Often yes, usually rear shocks run 100-200psi, but fork psi varies a lot, depending on the design. Get the sag around 25% (maybe slightly less sag in the front than the rear) and see how it rides (that’s what really matters), adjust on the trail as needed.

How much psi does a Fox fork have?

Do not exceed maximum air pressure: 34 FLOAT and Rhythm maximum air pressure is 120 psi. 34 TALAS maximum air pressure is 200 psi. The recommended settings in this tuning guide are designed to be a starting point, in order to get you out on your first ride in as few steps as possible.

How much psi should I put in my bike shock?

Start with where you should be in the manual, assess how much travel you’ve used after a typical ride. If you are not cycling through your suspension, let out 5 psi at a time per ride.

What PSI should my front forks be?

On the biggest stuff you hit, you should be close to bottoming or bottoming but not hard. If you’re running into not using all the travel, drop the pressure in small 5psi decrements. If you’re bottoming, raise pressure a bit.

Can Fox shocks be adjusted?

The optional rebound adjust feature on FOX 2.0 coil-over shocks gives the ability to externally adjust the shock rebound damping. Adjustments are made using a small flat- bladed screwdriver on the eyelet at the end of the shock shaft. For slower rebound, turn the screw clockwise.

Can you rebuild Fox shocks?

FOX’s shocks are ‘serviceable’ – meaning each shock can be rebuilt with new internals, and a new nitrogen gas charge can be applied to the shock, complete ride refreshment.

What should the pressure be on a Fox rear shock?

300 as recommended by Fox. 250 should be no problem. That seals and so forth will actually handle more than 300psi but only under STATIC (not moving) conditions. They have to be able to handle more as the pressure in the air chamber ramps up as the shock is compressed obviously.

How do you adjust the shock on a mountain bike?

If you require less sag simply add air to the shock, if you require more sag lower the air pressure. Add air in 10 psi increments and each time repeat the process until you reach the required sag. Pro-Tip: While setting the sag, hold just one brake, not both or you will cause incorrect readings.

How much does a fox mountain bike shock cost?

FOX is now offering new special edition decal kits in 15 popular colorways. Retailing for $25 USD, the kits include fork and shock decals to fit almost every FOX fork and shock model. This opens in a new window. This opens in a new window. Paul Lange Hungary Kft. The Single Track LTD. Omnico LTD. SPORTSON55 INC.

What should the SAG be on a Fox suspension?

To achieve the best performance from your FOX suspension, adjust the air pressure to attain your proper sag setting. Sag is the amount your suspension compresses under your weight and riding gear. Sag range should be set to 25–30% of total shock travel. Watch the sag setup video at ridefox.com/sagsetup 1.