What is RockShox PopLoc?

Product Description. RockShox PopLoc sprint remote lever is time-saving ergonomically superior handlebar-mounted remote. Cable actuated system to lockout your fork. Handlebar mounted, remote-control damper adjuster for RockShox forks or rear shocks with remote compatibility.

How do you adjust the rebound on a RockShox fork?

For recommended rebound settings go to www.rockshox.com/app. After setting sag, adjust the rebound damper, go for a ride, and adjust again as preferred. To decrease rebound speed (slower return), turn the rebound adjuster clockwise. To increase rebound speed (faster return), turn the rebound adjuster counter-clockwise.

How does RockShox lockout work?

The lockout and rebound systems work by using pressurized oil to change the speed of compression and decompression. A completely disengaged lockout will allow the oil to flow quickly through the chamber while a fully-locked suspension will completely restrict the flow of the oil.

What PSI should my RockShox be?

RockShox Setup Guide | SRAM. Max pressure should not exceed 163 psi. Rebound suggestions are set from the full clockwise/full slow position.

How do you adjust rebound compression?

Stand next to your bike and compress the fork with your body weight. Quickly release the fork and let it bounce back. Adjust the rebound until the fork rebounds as fast as possible without causing the front wheel to ‘jump’ off the ground.

Are lockout forks worth it?

You definitely don’t need a lock-out on your fork. On steep smooth climbs where you’re out of the saddle a lock-out is nice – as it prevents the front end from bouncing up and down. However it’s not necessary, and unless you spend a lot of time out of the saddle it isn’t important at all.

How much pressure should I put in my front forks?

Start with where you should be in the manual, assess how much travel you’ve used after a typical ride. If you are not cycling through your suspension, let out 5 psi at a time per ride.

How much pressure do you put on RockShox Fork?

Tighten the PopLoc assembly with 25 pound-inch of pressure. Rotate the compression dial on the top of the right arm of the RockShox fork counterclockwise until it reaches capacity. Depress the button on the PopLoc assembly.

How does a poploc work on a bike?

As the wheel of the bike rolls over an object, the cylinder compresses down into the chamber, and once the wheel clears the object, air pressure forces the cylinder back up and into position. A PopLoc gives riders the advantage of increasing or decreasing the distance the cylinder travels up and down with the flip of a thumb lever.

Where is the compression dial on a RockShox Fork?

Rotate the compression dial on the top of the right arm of the RockShox fork counterclockwise until it reaches capacity. Depress the button on the PopLoc assembly. Slide one end of the PopLoc cable housing into the hole located on the right-side wall of the assembly. Slide the other end over the nipple, near the compression dial on the fork.

What is the poplok and what does it do?

The PopLok is a cable actuated remote lock-out device. I,ve found it usefull in steep rock gardens where you don’t wanna go over the bars because of fork compression (fork dive). Hit the poplock lever and you can lock out the fork!