How do I open Cisco AP web interface?

Choose Services > HTTP. The Services: HTTP – Web Server page is displayed. In the Web-based Configuration Management field, select the Enable Secure (HTTPS) Browsing check box. In the Domain Name field, enter a domain name, and then click Apply.

How do I find my Cisco AP IP address?

To find the Access Point’s IP address

1. Open utility window, make sure Get IP addr is selected in the Function box.
2. Type the Access Point’s MAC address in the Device MAC ID field.
3. Click Get IP Address.
4. Write down the Access Point’s IP address that appears in the IP Address field.

How do I assign an IP address to a Cisco access point?

– Use the Cisco IP Setup Utility (IPSU) to identify the assigned address. You can also use IPSU to assign an IP address to the access point if it did not receive an IP address from the DHCP server.

How do I configure a Cisco router?

Perform these steps in order to configure the dynamic routing in a Cisco router:

1. Choose Configure > Router > Static and Dynamic Routing.
2. Select the RIP and click Edit.
3. Check Enable RIP, choose the RIP version, and click Add.
4. Specify the Network address to be advertised.
5. Click OK.

What is the default password for Cisco access point?

In the absence of a DHCP server, the access point will fallback to the default static IP address after 60 seconds. Step 3. Login with the default credentials. The default username is cisco, and the default password is cisco.

How do I reset my Cisco access point?

Reset Cisco Wireless AP to factory defaults

1. Connect the console cable.
2. Unplug the power or network cable if connected to a POE switch.
3. Press and hold the Mode button.
4. Plug the power back into the AP.
5. Wait until the output on the console says button is pressed.

What are the Cisco router commands?

Basic Cisco Router Show Commands

• Router#show interfaces. This command shows the status and configuration of interfaces.
• Router#show controllers [type slot_# port_#]
• Router#show flash.
• Router#show version.
• Router#show startup-config.

What is a cisco access point?

A wireless access point (WAP) is a networking device that allows wireless-capable devices to connect to a wired network. It is simpler and easier to install WAPs to connect all the computers or devices in your network than to use wires and cables.

How to configure a Cisco Aironet 1242ag-cisco community?

I just started a new job and there is a box of Aironet 1242AG access points they’d like me to configure. I plug it into a C2960 PoE switch and I can see it gets an ip address. I try to type that ip address in my browser to configure the access point, but get I messaged that 192.168.000.XXX refused to connect.

How to access the Web graphical user interface-Cisco?

When you log in for the first time, the Accessing Cisco Switch page appears. On the Accessing Cisco Switch page, click the Wireless Web GUI link to access switch web GUI Home page. Choose Configuration > Wizard to perform all steps that you need to configure the switch initially.

What is the username and password for Cisco management interface?

The management interface IP address is same as the gigabitethernet 0/0 (also known as service port interface). When you log in for the first time, you need to enter HTTP username and password. By default, the username is admin and the password is cisco. You can use both HTTP and HTTPS when using the service port interface.

Where to plug null modem into Cisco switch?

Connect one end of a null-modem serial cable to the switch’s RJ-45 console port and the other end to your PC’s serial port. Plug the AC power cord into the switch and a grounded 100 to 240 VAC, 50/60-Hz electrical outlet.