Where is the camshaft position sensor on a 2001 Dodge Dakota?

Camshaft Position Sensor Location The camshaft position sensor on 2001 4.7-liter V-8 engine is located at the front/top side of the right cylinder head, see (Fig. 2). Fig. 1.

Where is the camshaft sensor located on a 2000 Dodge Dakota?

It’s on rear of the engine, drivers side. It goes through the transmission bell housing. Use penetrating oil on it, and be carefull in pulling it out.

Can you change camshaft position sensor?

This should be done any time you work with sensors or electrical components. It may be easiest to remove and replace the camshaft sensor from under your vehicle, but it can also be done from the top by removing the air filter housing.

What happens when Cam sensor goes bad?

A failing camshaft position sensor begins losing its ability to quickly transfer data. Mismatched fuel delivery and ignition timing, even if off by a few milliseconds, will cause your vehicle to sputter, accelerate poorly, lack power, stall or even shut off.

Where is the cam sensor on a 2002 Dodge Dakota?

Before we start let me tell you that your 3.9L Dodge Dakota comes equipped with a camshaft position sensor and a crankshaft position sensor. The camshaft position sensor is located in the distributor and the crankshaft position sensor is bolted onto the transmission bell housing.

Can a car run without a camshaft position sensor?

The car doesn’t run. The engine will either start or stall if it doesn’t turn over. The engine will run poorly if the same sensor is unplugged and no signal is sent.

Can you drive with a bad cam sensor?

Yes, it is safe to drive with a bad camshaft sensor. However, the performance of your engine will not be as good and fuel consumption may increase. In some cases, the camshaft may need replacement if there are any other symptoms of failure on this component. …

What causes a cam sensor to go bad?

Over time, the camshaft position sensor can fail, or become worn down, due to accidents or normal wear and tear. There are a few warning signs to watch out for before your camshaft position sensor completely fails and shuts down the engine, making replacement a necessity.