How do I fix my TV remote sensor not working?

Follow the steps below to troubleshoot this issue:

1. Make sure the remote control is set properly to control the TV.
2. Make sure there is nothing in front of the infrared (IR) sensor on the TV that may be blocking the signal from the remote control.
3. Make sure you are pointing the remote control towards the IR sensor.

Why would my remote stop working?

There are a number of reasons why your remote may not be working. The most common are physical damage, battery issues, pairing issues, or issues with the infrared sensor on the remote or TV.

Why would a remote stop working?

How do I fix my cable remote?

Troubleshooting Steps

1. Replace your batteries.
2. Make sure your Spectrum Receiver (cable box) is turned on.
3. Change channels by pressing the buttons on your receiver (if available).
4. Remove any objects (e.g. furniture) around your receiver.
5. Position your receiver at a different angle so it can detect your remote.

Why is my x1 remote not working?

If the buttons on your Voice Remote (model XR11) are still unresponsive, you may need to perform a factory reset. Press the Setup button until the LED at the top of the remote changes from red to green. Press 9-8-1. The LED will blink green twice to indicate that the remote was reset.

Why will my remote not change channels?

Remote will not change channels or turn on the TV. Batteries are low, dead, or inserted incorrectly. Verify the batteries are inserted in the correct direction. If the box turns ON or OFF, then install new batteries in the remote and try again.

What to do if your TV remote is not working?

One Minute Fix- Try this method first before going out to buy another TV remote. I have fixed numerous TV remotes (and sound bar remotes) by using this method. With the batteries out and holding down the power button you are basically draining all excess battery.

How can I tell if my Remote Control is working?

Be sure the remote control is emitting the signal. Use a your mobile phone camera and check the emitter on the front of the remote control. Press a button on the remote to see if you see a red light. If you see the red light, it means the remote control is working.

How can I tell if my TV remote is dead?

This way you can verify if your batteries are dead or the remote control has been damaged. Bear in mind that it is possible that, if your remote control has been damaged by liquids or shocks, the infrared signal might still be visible, but is sending faulty data. Update the TV software to the latest version .

How to troubleshoot a Sony TV remote control?

First, check whether the problem is due to the TV or the remote control. If the problem is due to the remote control, you will be guided in Section by remote control type. Start checking from Section A. Check that TV buttons can be operated. If TV buttons can be operated, proceed to Section B: Checking items of the remote control.