How tight should a Polaris track be?

just use your hand and push down firmly in the middle of the track near the rubber bumpers and it needs to be more than 2″. i run mine at 2.75 and i did have it at a little less than 2 before i knew how important tension was.

How do you adjust the Polaris RMK suspension?

Turn a clicker counter-clockwise to decrease damping for a softer ride. Turn a clicker clockwise to increase damping for a stiffer ride and less bottoming. Always adjust the clicker at least one click below full stiff (full clockwise) or shock damage will occur.

What happens if snowmobile track is to tight?

You’d lose a good inch or so if they’re not. Make sure you have loosened the bolts on the rear wheels so the shaft can slide forward. You may have to use a rubber mallet to get them to go forward as they do tend to stick sometimes.

What does the limiter strap do on a snowmobile?

Limiter straps are attached to the front arm and the front of the skid. Their purpose is to limit how far the center shock can extend, which in turn affects the weight transfer of the snowmobile suspension and the amount of ski pressure.

What’s the best tension for a Polaris track?

The polaris manual wants you to run it too tight. The general rule of thumb that I have been told on the edge chassis is to run the track as loose as possible without it slipping. I think about 1-1.25″ seems to be the best for the slack measurement you are referring too. This will have you a better top speed as well and also reduce hifax wear

Where can I find the Polaris track fitment guide?

This will provide you with key information for selecting the correct replacement track for your Polaris snowmobile. The guide lists Polaris snowmobile models in alphabetical order. So your first option is to search by simply scrolling down looking at the left hand column for your model of sled and then checking the year column for the correct year.

What’s the tension on a cat m track?

Been a cat M guy since 2005 and have always ran track a smidge tighter than ratcheting,,,, so super loose as in hanging down at least 4″ when picked up at rear. By the book for the Pro seems ridiculously tight, with 10lbs only 1/2″,,,, seems too tight. thoughts??

How do you find the track for a Polaris snowmobile?

Use it to shop with confidence for your replacement snowmobile track. In general, determining what snowmobile track will fit your Polaris sled will consist of determining what length, width, lug height and pitch will fit your sled. Once you determine these dimensions then you need to consider the conditions you ride in most often.