How do I reset my Danfoss TP5 thermostat?

The day will only appear on models TP3 and TP5.) Slide the battery cover to the right but leave the buttons visible. The unit may be reset to 12:00PM (MO) and the factory set programme by pressing and holding down the four buttons, temperature s and t, time + and -, until the display goes blank.

How do I set the time on my Danfoss TP5?

The Danfoss TP5 allows you to set 12 different times and temperatures for your thermostat while also allowing you the freedom to easily change the temperature if you ever get too hot or too cold. Press the “+” and “-” buttons to set the device to the current time.

Why is my Danfoss thermostat not working?

Your Error on screen simply is saying the thermostat is set to off. You can try one thing, if you remove the batteries and replace them in the reverse direction for 1 full minute then remove them and replace them with NEW known good fully charged batteries you should be able to set it and it should work.

How do I program Danfoss TP5000?

TP5000-RF Si – Reset the unit by pressing the recessed reset button. Press and hold V and +buttons (fig. 13)for 3 seconds (TP5000 RF Si now transmits unique signal continuously for 3 minutes). RX1 – Press and hold buttons PROG and CH1 for 3 seconds until green light flashes once.

How do Danfoss thermostats work?

The distance between the valve seat and the valve cone determine how much water is flowing through the valve and to the radiator. The valve cone is operated by the thermostat, which senses change in the room temperature. By turning the handle on the thermostat you are able to select the desired room temperature.

Should your thermostat be on auto or on?

If you want to keep the energy bills low, you should set the thermostat to ‘Auto’. However, if you prefer more even distribution of heat inside the house, it’s better that you set the thermostat setting to ‘On’.