What kind of oil goes in a bobcat?

15W-40 Bobcat High Performance Gas Diesel Engine Oil – 1 Gallon or 2.5 Gallon Jug (1 Gallon Jug)

How often should you change oil in a bobcat?

every 12 months
Engine Oil and Filter – Replace every 12 months/250 hours under standard operating conditions, or 100 hours when operating in severe conditions. Engine / Hydrostatic Drive Belt – Adjust the idler arm stop. Check belt for wear or damage. Fuel Filter – Replace filter element every 12 months or every 500 hours.

How much oil does a bobcat hold?

How much oil does a 643 Bobcat take? Engine oil capacity is 7 qts.

What kind of oil does a bobcat 873 take?

Engine Oil, 10W30 – 1 Quart, 7354875.

What oil does a bobcat 743 take?

Use Class SE of SF motor oil (5W-30 at temperatures below 10°F (23°C]). Service Manual Revised Sept. 90 -8A-2- Page 7 ENGINE SPECIFICATIONS All dimensions are given in inches.

How often should you change the oil in a skid steer?

Every 250 to 500 hours of use, periodic maintenance should be performed. Periodic maintenance involves changing the engine oil, V-belt and all filters including the hydraulic, fuel and possibly air filters.

How many quarts of oil does a Bobcat s185 take?

11 qts
11 qts. (10,4 L) Engine Oil with Filter………………………

How many quarts of oil does a Bobcat s160 take?

11 qts. (10,4 L) Engine Oil with Filter………………………

What oil does a 753 Bobcat take?

753 G-Series Skid-Steer Loader calls for a “AW 32 Hydraulic Oil Fluid (ISO VG 32, SAE 10W)” and needs about three 5Gal buckets.

What kind of engine does a bobcat 873 have?

A ’99 873 should have a Deutz oil cooled engine in it. And if you don’t know the machine service/repair history, at 2400 hrs, you might save yourself some aggravation by going ahead and replacing the timing belt. If it lets go, gets more [less] interesting. The 873 was a rather big machine, but it’s weak point was the loader arms.

How often should I change the oil in my Bobcat?

I decided to check my manual and it recommends: Engine oil & filter @ 500 hrs or 250 hrs if in severe operating conditions. Fuel filter @ 250 hrs. Hydrostatic filter, charge filter, steering valve filter (A300 only), & reservoir breather @ 500 hrs. Air Filters are recommended to check daily but service only when required.

What kind of oil does a bobcat use?

The chain case level is the pipe plug in the very front of the machine. Like barklee, I use AW hyd oil in chain case and hyd system, either AW32 or AW46 for higher ambient temps. And I would advise checking out that oil cooler and making any needed repairs.

Where is the timing belt cover on a bobcat?

There is typically one special “torx plus” screw that holds the timing belt cover on, seems like it’s at the bottom of the cover, unless someone previously threw it away. It’s simply a notched, flat, timing belt.