How do you unscrew an apple screw without a screwdriver?

Remove Pentalobe Screws Without the Correct Screwdriver

1. Step 2: Bend Your Rod. Cut off a small section of your thin metal rod and bend it as shown.
2. Step 3: File the Rod. File the two edges of your metal rod until the end becomes a rectangular bar.
3. Step 4: File Some More. Now file down the modified metal rod.

How do u take the back off an iPhone 4s?

Remove the back plate

1. Using your security screwdriver, remove the 2 screws on either side of the dock connector port.
2. Set them aside.
3. Gently slide up the back plate by applying a bit of pressure along the bottom with your thumbs and sliding upwards.
4. Now lift off the back plate and set it aside.

What screwdriver do you need to unscrew an iPhone?

For most iPhones, you’ll need a pentalobe screwdriver and a #000 Phillips driver. You can order these individually from iFixit, or get an essential/pro tech toolkit which will also include any and all other tools that you’ll need to perform most repairs.

Why does Apple use pentalobe screws?

“[Apple] chose this ‘pentalobe’ fastener specifically because it was new, guaranteeing repair tools would be both rare and expensive,” Wiens explained. He also noted that the screws are only used on the exterior of the device, merely to make it difficult for end users to get inside.

Is Pentalobe the same as Torx?

Pentalobe screws were first used in the iPhone 4. The screws used were slightly smaller than a Torx TS1, about 0.8 mm. If brought in to an Apple Store for repair, iPhone 4 models with #00 Phillips screws, if any, were replaced with 0.8 mm pentalobe screws.

How long does a iPhone 4s battery last?

iPhone Q&A

Can iPhone 4 battery be replaced?

The Apple warranty covers a dysfunctional battery at no cost. But if your device is out of warranty, Apple offers battery replacement service for iPhone 4 for a standard $79 plus shipping. The repair may take up to three weeks.

How many hours does the iPhone 4 battery last?

What can I use instead of a screwdriver?

What to Use if You Don’t Have a Screwdriver

• Flathead screwdriver.
• Coin.
• Butter knife.
• Hacksaw.
• Toothbrush.
• Old CD.
• Pliers.
• Thumbnail.

What type of screws does Apple use?

The pentalobe security screw (Apple nomenclature), or pentalobe screw drive, is a five-pointed tamper-resistant system used by, but not limited to, Apple in their products.

Where can I get replacement screws for my iPhone 4?

The pentalobe screws are already prone to stripping, even with the correct screwdriver. It’s recommended you purchase replacement philips screws to put back in once you’ve removed the pentalobe screws from your phone. You can find both the replacement screws and screwdriver in iFixit’s iPhone 4 Liberation Kit. Rep: 3.5k Was this answer helpful?

Can a pentalobe screw be removed from an iPhone 4?

If you believe you have a stripped screw on your iPhone4, 4s, and 5s, you may want to take another look as they are held together with Pentalobe screws. Apple chose to use these type of odd screws as they are considered tamper resistant. A small eye glasses repair screwdriver will not remove these screws.

What’s the best way to remove a stripped screw from an iPhone?

2. Super Glue Method– Put a small amount of super glue in the stripped screw. Hold your screwdriver on the screw for about 20 seconds and then try to unscrew it. (SEE VIDEOS BELOW) 3. Solder Gun Method– Solder a sewing needle to the stripped screw. Once it is soldered in place slowly turn it counter clockwise to remove the screw.

Is there a way to unscrew a screw without a screwdriver?

Once the plastic is soft you can insert it in the head of the screw and allow the plastic to harden once more. Once it is hard try to turn the screw counterclockwise to unscrew it. Use this method for removing very tiny screws without a screwdriver. Very tiny screws are particularly difficult to remove without the proper tools.