Can you convert an alternator to a motor?

They take a battery DC supply and produce a three-phase AC suitable to drive a delta-connected motor, and they work well with converted alternators. We’ve found that an alternator drives well as a motor from a 36V or a 48V supply, and as long as a controller with enough power is used then they do so reliably.

How much power can an alternator produce as a motor?

But nowadays, a single alternator can produce power up to 2500 Watt, depending on the power demand. The power that can be produced by an alternator is determined by the alternator rating. The output of the alternator ranges from 40 Amp up to 120 Amp. For high-amp alternator, it can generate up to 300 Amp.

Is an alternator A brushless motor?

An alternator converts mechanical energy into electrical energy by spinning a magnetic field using a rotor to create energy. A brushed alternator uses carbon brushes to help conduct electricity, while a brushless alternator uses two sets of rotors that spin together to generate and transfer the electrical current.

Can you convert a 12v alternator to 24v?

While most vehicles use a 12 volt (12v) electrical system, many buses (and some boats) utilize a 24 volt system. The 24v systems that employ 12v batteries can be recharged with a 12v alternator by simply being plugged in like any other 12v battery.

Can you use a car alternator for wind turbine?

Turn a car alternator into alternative energy by building this cheap and easy homemade wind generator. You can use any vehicle alternator with a built-in voltage regulator. …

What is the minimum RPM of a 12v car alternator?

about 1,800 RPM
Typically, the lowest speed at which a car alternator is able to generate 12VDC is about 1,800 RPM. to DC to appropriately charge the battery. Thus, the alternator contains a diode rectifier circuit to convert the AC voltage to DC.

Do alternators charge at idle?

The answer is ‘YES’, yes the car battery does charge while the engine is idling. As long as the mechanical action of the alternator is taking place; that is, being turned by the engine crankshaft. Then the alternator is producing AC current, thereby charging the battery while your car is idling.

How much HP does it take to turn an alternator?

An alternator takes about 1 HP for every 25 Amps of power. At full output, a 100 Amp alternator will need about 4 HP. For a long time, most alternators don’t operate at full output.

Can I charge a 24 volt system with a 12 volt charger?

This requires only one bank of a 12V charger to be attached to the positive terminal of the first battery, and the negative terminal of the second battery. In the second example, to charge a 24V system simply use each bank of the charger on each 12V battery terminal leads.

How do you jumpstart a 24 volt car with a 12 volt car?

Connect a jump lead from the positive terminal to the positive terminal on the 24-volt truck battery. Connect a second jump lead between the negative terminal and the engine block or other ground connection in the 24-volt truck. Put the 24-volt truck in neutral and start it following the normal procedure.

What can you do with old alternators?

Alternators should be brought to your local scrap metal yard or auto recycler to be scrapped when they are no longer of use to you.

Can a Delco alternator be converted to a two wire?

Most of these conversions focus on the use of a Delco single-wire 10-SI alternator; however, a two-wire will work just as easily with a little adaptation. You can buy a new two-terminal alternator connector from just about any aftermarket parts supplier (GM# 36294493).

How to convert an alternator to a brushless motor?

Our Alternator Conversion Manual, “How to Convert an Automotive Alternator to a Hybrid Brushless Motor” shows in clear step-by-step instructions with photographs how to do the conversion. It also explains how to drive the alternator as a motor.

How much does it cost to convert an alternator to a motor?

A car alternator that can be readily converted to a powerful motor costs about $100.00, but a conventional brushless motor that produces about the same power output typically costs far more — well over $500.00 and is often more difficult to obtain with long order lead times.

How does an ESC work with an alternator?

They take a battery DC supply and produce a three-phase AC suitable to drive a delta-connected motor, and they work well with converted alternators. ESCs have two modes, one for motors with Hall-effect feedback sensors, and one for motors without such as our alternator.