What does 7 blinks mean on Panasonic plasma?

7 blinks indicates either SC, SU or SD board failure-or all 3. This is a known defect which Pana refuses to acknowledge & is worthy of a class action suit–go to Facebook: https://www.facebook.com/pages/Panasonic-Viera-Plasma-Failure-Page/152918558086845 and let the world know.

How do I reset my Panasonic plasma TV?

Normally; a hard reset can be done by unplugging the TV from AC mains wall socket, and re-plug it back after some minutes or hours. To perform HARD RESET of Plasma TV unit by pressing & holding VOL DOWN (-) on unit and MENU button on remote at the same time for about 3 seconds.

Why does my Panasonic TV keep blinking red?

The prime reason that the red light is blinking ten times on your Panasonic TV is the voltage issue on the DTV, Sub 5V, and Main 3.3V. In addition, the issue can occur due to the tuner power issues as well.

How do I troubleshoot my Panasonic TV?

How to Troubleshoot a Panasonic Viera TV

1. Unplug the power cable from the electrical outlet.
2. Replace the the batteries in the remote control, if the TV isn’t responding to it.
3. Check your fuse or breaker box to ensure power to the TV’s outlet is on.
4. Check that all connections on your Panasonic TV are stable and not loose.

What are the blink codes on a Panasonic TV?

There are 11 blink codes built into a Panasonic television, as of 2015, all of which relay the fault diagnostic circuit’s detection of errors within the TV. The blink codes vary from two blinks up to 12 blinks, each indicating a different problem.

What is the error message on Panasonic plasma TV?

Panasonic Plasma TV TC-P55VT50Error message 006 cannot connect… Panasonic Plasma TV TC-P55VT50 Error message…

What causes a Panasonic plasma 7 blink failure?

A common cause of “death” is the 7 blink failure. The problem is with one, both, or all of the following boards: SC board, SD board, and SU board. Most commonly, the SC board is the culprit.

How to use the recall button on a plasma TV?

* Hold down the {VOL -} button ON THE PLASMA TV. * Press the {RECALL} button 3 times on the remote. * The Service Menu will be displayed. * Use {1} {2} on remote to navigate main menu items. * Use {3} {4} on remote to navigate sub-menu items. * Use {VOL+} {VOL -} on remote to change item value. Once a value is changed, THE CHANGE IS MADE.