Guidelines

Why does my Aprilaire humidifier not working?

Why does my Aprilaire humidifier not working?

Common solutions for: Aprilaire Humidifier not getting water The water inlet valve is an electrically-controlled valve that opens to allow water to enter the humidifier. If the water inlet valve is clogged or defective, the humidifer will not fill with water. Use a multimeter to test the valve for continuity.

How do I reset my Aprilaire humidifier?

Purchase only Genuine Aprilaire Water Panels to maintain performance. If your humidifier is equipped with an automatic control, after replacing the Water Panel, turn the control knob to the “Test/Reset” position until the “Change Water Panel” light blinks to reset the Water Panel change indicator timer.

How does The Aprilaire Model 700 fan work?

Aprilaire 700 Whole House Fan Powered Humidifier. The Aprilaire Model 700 Humidifier is a whole-home solution that helps you achieve total comfort through humidity control. Our evaporative humidifiers work by piping water into the distribution tray located at the top of the humidifier.

What happens if your Aprilaire humidifier is not working?

No one wants chapped, dry hands or enjoys constant thirst but that’s what happens when your Aprilaire Humidifier’s not working. Maybe it’s not getting water. Maybe the drum’s not turning. Maybe it’s overflowing, or the fan doesn’t work.

How many gallons of water does an Aprilaire need?

Capacity is high because an average-size home (10,000 cu. ft.) requires the addition of approximately 9 gallons of water per day to maintain 35% relative humidity when the outside temperature is 20°. The smallest Aprilaire Humidifier under most operating conditions, has this humidifying capacity.

Why does my humidifier have a 110 volt plug?

If your humidifier has a 110 volt plug then the power for the soloniod valve comes from within the humidfier. you said that somthing inside clicks, which means the control board inside the humidfier is trying to switch its own internal 24 volts to the soloniod. it is possible that the relay built into the control board is failed.