How do I setup my Linksys wireless G router as an access point?

Configuring an Access Point as a wireless repeater

1. Access the router’s web-based setup page.
2. When the router’s web-based setup page opens, click Status then click Wireless.
3. Take note of the MAC Address.
4. Connect a computer to the access point.
5. Assign a static IP address on the computer.

How do I use my Linksys router as an access point?

How to change a Linksys router to AP mode

1. Connect a computer to the Linksys router and launch a web browser.
2. Visit the following router configuration page:
3. You are prompted to enter a username and password.
4. Click on Advanced settings > Administration > Operation Mode.

How do I connect my WRT54GL?

How to Set Up a Linksys WRT54G Wireless G Router

1. Step 1: Connect the Modem. Plug the Ethernet cable from your cable or DSL modem into the Internet port on the router.
2. Step 2: Connect Your Computers.
3. Step 3: Connect the Power.
4. Step 1: Log In.
5. Step 2: Open Wireless Settings.
6. Step 3: Name the Network.
7. Step 4: Set Up Security.

Is the Linksys WRT54G a wireless access point?

Most computer retailers offers the Linksys WRT54G Wireless Router for about $49 and Wireless Access Points for $99. Why waste $50 if you don’t have to? You can convert a wireless router to become a simple access point if that’s all you need. This is not an article on how to create a wireless-to-wireless bridge, as some have misinterpreted it to be.

How to configure a Linksys access point?

Linksys Wireless-G Access Point (WAP54G) Linksys Wireless-G Router (WRT54G) To configure the access point as a wireless repeater, you need to perform two steps: Checking the Wireless MAC Address of a Wireless Router/Access Point. Setting-Up Wireless Repeater Mode on the WAP54G.

Is the Linksys wireless G access point compatible with Windows XP?

Future-proof your wireless network with the Linksys Wireless-G access point. You’ll enjoy Wireless-B connectivity today, and be prepared for a high-speed Wireless-G tomorrow. The Linksys Wireless-G access point is compatible with Windows 95, 98, Me, NT 4.0, 2000, and XP.

Can a router be a wireless access point?

There were three basic configuration changes you made to set up your router as a wireless access point. If you did not turn off DHCP, when you plug your router into the network (after configuration), your WAP may provide IP addresses to clients on the wired network, and this may be inappropriate.

https://www.youtube.com/watch?v=oenmXhN9sqA