What is code for stair nosing?

The nosing on treads, believe it or not, has a code minimum and maximum of how far the nosing projects over the next stair. Nosings are required to overhang a minimum of ¾-in. to a maximum of 1-¼-in. Also the maximum nosing radius cannot exceed 9/16 of an inch.

What is code for tread depth on stairs?

The minimum tread depth shall be 10 inches (254 mm). The tread depth shall be measured horizontally between the vertical planes of the foremost projection of adjacent treads and at a right angle to the tread’s leading edge.

What is the International Building Code for stair treads?

International Building Code for Stair treads and risers 1009.3 Stair treads and risers. Stair riser heights shall be 7 inches (178 mm) maximum and 4 inches (102 mm) minimum. Stair tread depths shall be 11 inches (279 mm) minimum.

How are commercial stair widths determined by IBC?

Unlike residential stairs per the IRC, where the width is just a given measurement, commercial stair width per the IBC is based on capacity. In order to determine this the code refers us to Section 1005.1, but before we look at this section the code does say that the minimum width shall not be less than 44 inches.

What do you need to know about stair tread nosing?

1 Stair tread nosing projection past vertical riser below (3/4″ to 1 1/2″) required on stairs with solid risers 2 Tread nose projection uniformity (<= 3/8″ variation) 3 Stair tread nosing curve radius (=< 9/16″) 4 Tread Nose not required if tread depth is => 11″ 5 Tread Nose not required on open stair treads (open riser)

What are the height requirements for stair treads?

A walking-surface that provides a coefficient of friction of 1.02 dry and 0.98 wet will comply with ADA, OSHA, and most local building codes and insurance requirements. Stair riser heights shall be 7 inches (178 mm) maximum and 4 inches (102 mm) minimum.

https://www.youtube.com/watch?v=TwPPn-tJtvk