Users' questions

How do you remove the rear bumper on a VT Commodore?

How do you remove the rear bumper on a VT Commodore?

Open the boot and remove the screws retaining the top of the bumper to the body. Then in the boot, remove the carpet coving the tail lights and remove the nuts that hold the rear bumper on either side of the of the boot. Then remove the screws located in the wheel arch. Check under the bumper for any screws down there.

How do you remove a VE Commodore bumper?

  1. Unscrew the two bolts in the centre of the bumper (Red), then remove the two scrivets (Green).
  2. Removal all screws running along the bottom of the bumper.
  3. Now we need to remove the bolts which attach the bumper to the fender.

How do you remove the rear bumper on a VT?

how do you remove the vt rear bumper? Open the boot and remove the screws retaining the top of the bumper to the body. Then in the boot, remove the carpet coving the tail lights and remove the nuts that hold the rear bumper on either side of the of the boot. Then remove the screws located in the wheel arch.

How to remove rear bumper on Corvette C7?

You are just loosening it to reveal the cable that attaches to your trunk latch. Once you locate this, you must remove it from the latch. Next you want to remove the rubber gasket trim piece that covers the Torx screws that you need to remove.

How to remove the rear bumper on a Holden Commodore?

Discussion in ‘ VT – VX Holden Commodore (1997 – 2002) ‘ started by Noy, Apr 15, 2007 . how do you remove the vt rear bumper? Open the boot and remove the screws retaining the top of the bumper to the body. Then in the boot, remove the carpet coving the tail lights and remove the nuts that hold the rear bumper on either side of the of the boot.

How to remove rear bumper on VZ sedan?

You should now be able the pull the bumper away from the side that you wish to access , put some thing under the bumper to take its weight while you push the reverse sensor back into position , once that’s done reverse all and it should be easy just to replace all the clips and nuts . Click to expand… I’ll give that a go on the W.E.