Can you adjust the headlights on a Mazda 6?

Luckily, Mazda’s headlights can be easily adjusted by the average do-it-yourselfer.

How do you adjust the headlights on a Mazda?

You can adjust the headlights on your Mazda 3 by using the 10mm adjustment bolt on the backside of the headlight housing assembly. This bolt will allow the only adjustment available on the Mazda 3. Adjusting your Mazda 3’s headlights is necessary whenever you replace the housing assembly.

How to set the headlights on a Mazda 6?

Set up a screen as shown in the figure below for aiming the headlights. 2. Adjust the tire air pressure to the specification. 3. Position the unloaded vehicle on a flat, level surface. 4. Seat one person in the driver’s seat. 5. Position the vehicle straight ahead and perpendicular to a wall. 6. Set the headlights 3 m {10 ft} from the wall. 7.

Where are the adjustment screws on a headlight?

Open the hood and locate the adjustment screws: These can be found on the top-center and side-center of the headlight assembly. These two screws control the vertical and horizontal directions of the beams. Use a standard screwdriver to adjust each one until the light hits the desired mark on the wall. Close the hood.

What’s the best way to Park a Mazda 6?

Luckily, Mazda’s headlights can be easily adjusted by the average do-it-yourselfer. Park the Mazda 6 one foot away from a large wall or garage door. You will need 25-feet of room to back up; the ground should be level in order to allow for accurate alignment of the beam. Mark the wall with the painter’s tape along the axis points of the headlights.

Why are the lights on my Mazda Too High?

If the lights are not properly aligned, you could experience poor night driving conditions, or others may not see you coming or may even be blinded by lights that shine too high. Luckily, Mazda’s headlights can be easily adjusted by the average do-it-yourselfer.