What is the default installer code for a Simon XT panel?

4321
Installer code Depending on how the access code is set, the default installer code is 654321, 54321, 4321 (factory default), or 321.

How do I reset the code on my GE Simon XT?

You can reset an Interlogix Simon XT to factory defaults by first powering down the panel completely. Then hold down the four top buttons on the panel while the system is being powered back on. If successful, the Simon XT will reboot with its factory default settings fully restored.

How do I disarm GE Simon XT without code?

If you still cannot disarm using a 4 digit code, and do not have a keychain remote, then you must power down the system (Refer to “powering down your panel”) to stop the beeping. After powering down the panel, leave it powered down and call Technical Support during available hours for further assistance.

How do I program my sensors Simon XT?

Simon XT – Programming A Door / Window Sensor

1. Press or until SYSTEM PROGRAMMING then press.
2. Enter Installer Code 4321 (Call Brinks Home Security® if this code is different)
3. Press or until SENSORS then press.
4. Press again to place Simon XT into sensor learn mode.
5. Remove sensor cover or press button to learn.

How to change master code on Simon XT?

The master code is the only code that can add and delete other user codes and perform other various functions (such as entering date and time) on the alarm system. The master code can be changed, but cannot be deleted. To change the Master Access Code: 1. Press OK to enter the System Menu . 2. Scroll up/down to System Programming and press OK.

How to disarm GE Simon XT quick user guide?

GE Simon XT Quick User Guide GE Simon XT Quick User Guide Page 2 Arming & Disarming the System Arming (Turning on) Close all sensors (i.e. close doors and windows). The ready indicator should be on. Arm the system using either of the methods below. Arming Method – Stay Mode Press DOORS+WINDOWS button.

How to set the time on Simon XT?

1. Press OK to enter the System Menu . 2. Scroll up/down until the display shows Set Clock . 3. Press OK. 4. The display will show Enter Code . 5. Enter the master code and press OK. 6. Press OK again; the display will flash the Hours. 7. Scroll up/down to set the hours. 8. Press OK to accept. The display will now flash the minutes. 9.

How to bypass a sensor in Simon XT?

Bypassed zones will not sound an alarm. Bypassing: 1. After arming the system in the manor you wish, press the BYPASS button and enter the MASTER CODE. 2. Scroll up/down to find the sensor you wish to bypass. Press OK to bypass. 3. When the sensor is bypassed, the panel display will show “Bypassed”. Unbypassing: 1.