How do I access the HP V1910 switch?

Type the IP address http://169.254.1.2 in the address bar and press Enter. The login page of the web interface appears: b. Enter the username admin and the verification code (As shown in the image below. Example: T5DT), leave the password blank, and click Login.

What is the default username and password for hp switch?

The default username for first time configuration is admin, no password is required. Usernames and passwords are case sensitive.

How to login to a hp switch?

On the computer connected to the new HP Switch you need to: Open a browser software, enter the IP address of your Switch and access the HP Switch web interface. On the prompt screen, enter the administrative login information.

How do I reset my HP V1910?

5. Restore to factory default configuration….HP V1910-48G JE009A Factory reset – Password recovery capability enabled.

1. Connect switch cable to COM.
2. Open Putty on COM 38400 – 8 – 1 – N.
3. Powercycle the switch.
4. Press Ctrl-B at boot to enter extended boot menu.
5. Skip current system configuration.
6. Reboot.

How to enable password recovery on hp v1910 je009a?

HP V1910-48G JE009A Factory reset – Password recovery capability enabled. 08-05-2016 12:27 AM 08-05-2016 12:27 AM HP V1910-48G JE009A Factory reset – Password recovery capability enabled. I have got a HP V1910-48G JE009A on my desk without any credentials. This switch needs te be set to factory defaults. 7. Skip current system configuration 0.

How do I log in to my hp switch?

Open a browser software, enter the IP address of your Switch and access the HP Switch web interface. On the prompt screen, enter the administrative login information. After a successful login, the administrative menu will be displayed.

How to do factory reset on hp v1910-48g?

08-05-2016 06:42 AM Re: HP V1910-48G JE009A Factory reset – Password recovery capability enabled. Found a working solution in this case. Stumbled on a post through google that stated to connect port 1 & 2 of the swtich. Then power it on, and leave it on for about 5 minutes. As I thought this was bollocks but just figured I had time to test it.

How to route between subnets in hp v1910?

The switch will route between any subnets that it has an IP address in. The hosts need to use the address that’s on the 1910 as their “default GW”. (You need to configure each switchport to be in the correct VLAN (untagged) for their subnet. If you have multiple switches, you need to trunk the VLANs (tagged) between switches). 2.