Other

How do you use Altera in ModelSim?

by Rhyley Bryan

How do you use Altera in ModelSim?

Table of Contents

  1. 1.1. Open the Example Design.
  2. 1.2. Specify EDA Tool Settings.
  3. 1.3. Launch Simulation from the Intel Quartus Prime Software.
  4. 1.4. View Signal Waveforms.
  5. 1.5. Add Signals to the Simulation.
  6. 1.6. Rerun Simulation.
  7. 1.7. Modify the Simulation Testbench.
  8. 1.8. ( Optional) Run Simulation at Command Line.

How do you use a model SIM?

Step 4: Start Simulation

  1. Go to Simulate, click Start Simulation.
  2. At the Design tab, search for work, then expand the work and select your testbench file.
  3. At the Libraries tab, click Add.
  4. Select library lpm, then click OK.
  5. Repeat step 3 for more libraries.
  6. Click OK.

How do you run simulation in Quartus?

Running Simulation Using the Quartus II NativeLink Software

  1. Step 1: Check Settings. On the Assignments menu, click EDA Tool Settings to open the Settings dialog box and then click Simulation.
  2. Step 2: Run Simulation. Go to Tools menu, select the Run EDA Simulation Tools, and choose which type of simulation you want to use:

How to manually run simulation on ModelSim-Altera?

To manually run simulation without using the Quartus ® II NativeLink feature, perform the following steps. You can use these steps for the ModelSim ® -Altera ® and ModelSim SE/PE software.

Which is the best Altera software to use?

As an alternative you can consider using the ModelSim-Altera version, which comes with pre-installed Altera libraries, like the altera_mf. This ModelSim version can be found at ModelSim-Altera Software. There is even a free version called “ModelSim-Altera Starter Edition”.

How to simulate an Altera megafunction using…?

___Hi, everyone. I have instantiated a PLL using the Megawizard in Quartus II. Then I wanted to simulate it using ModelSim SE because Quartus II 10.1 doesn’t have a built-in simulator. I copied builtInPLL.vhd (output of the Megawizard) and PLL_tb.vhd (testbench) to the directory of the ModelSim project.

Where to find Altera instance in RTL simulation?

When I start the RTL simulation, I see my top-level file in the folder work (in the Library Window), but not the Altera instance for the PLL (Verilog file). Question: How can I setup Quartus or ModelSim in order to see my top-level file AND the Altera instance for the PLL?

https://www.youtube.com/watch?v=qZNL1C0TwY8